R
ASSEMBLY INSTRUCTION
|
rearTWIST BNC 75 Cable Connector -
Crimp version
A
B
Boot
[ ]
C
A: 12 .473”
[ ]
B:5 .197”
D
Don't damage the foil!
(if existing)
E
Pin flush to the insulator
X
Labeling
Crimp ferrule
[ ]
C: 4 .16”
W
Slide the boot onto the cable
A
- Position the labeling to the cabelend
Slide the crimp ferrule onto the cable
B
Prepare cable as shown
C
- Use an adjustable coaxial cable stripper
Spread the braided shield
D
(It`s easily with the NEUTRIK
“SHIELD-SPREADING-TOOL”!)
Crimp the pin
E
®
- position the pin on the center conductor
- Crimp the pin with the tool
(For best crimping-results it is recommended to use the original
Neutrik crimp tool
- HXBNC with the corresponding insert
or hexcrimp acc. to IEC 803-W (SW 1.7)
or squarecrimp acc. to IEC 803-2 (SW 1.6)
- Pin can also be soldered (Optional)!
- Straighten the pin if misaligned.
Insert the cable into the connector body
F
Slide the crimp ferrule over the shield to the front
G
and push the cable to it`s end position until you
hear a snap noise.
F
G
I
X
H
Assembled Connector
NEUTRIK AG LI T: +423 / 237 24 24 F: +423 / 232 53 93
NEUTRIK USA Inc. USA T: +1 704 / 972 3050 F: +1 704 / 438 9202
NEUTRIK UK Ltd. UK T: +44 1983 / 811 441 F: +44 1983 / 811 439
NEUTRIK Vertriebs GmbH DE / NL / AT/DK T: +49 8131 / 280 890 F: +49 8131 / 280 830
Draft. Nr.: BDA 076 / 3102M0771 Update: 17.02.2012
( )
I I
Data subject t o change without prior n otice. 2012 NEUTRIK . ALL RIGHTS R ESERVED. NEUTRIK are regist ered trademark.
www.neutrik.com
RIMP
C
!
ION
T
RA
OPE
H
Please note:
Position the connector body
Flush with the die face.
Crimp the ferrule with the tool
H
(For best crimping-results it is recommended to use the
original Neutrik tool - HXBNC with the corresponding insert)
Snap the boot onto the connector body
I
NEUTRIK France FR T: +33 1 / 4131 6750 F: +33 1 / 4131 0511
NEUTRIK Tokyo Ltd. JP T: +81 3 / 3663 4733 F: +81 3 / 3663 4796
NEUTRIK Hong Kong Ltd. HK T: +852 / 2687 6055 F: +852 / 2687 6052
©
® ®
R