Neutrik NBNB75GUU11 User Manual
ASSEMBLY INSTRUCTION
BNC
A
|
75 Cable Jack Panel version
W
A
Slide the crimp ferrule onto the cable
B
X
Prepare cable as shown
- Use an adjustable coaxial cable stripper
Labeling
Crimp ferrule
[
B
A: 16
B: 9
.630”
[
.354”
]
]
C: 4
[
.16”
]
C
Spread the braided shield
(It`s easily with the Neutrik
“SHIELD-SPREADING-TOOL”!)
Crimp the pin
D
- position the pin on the center conductor
- Crimp the pin with the tool
(For best crimping-results it is recommended to use the
original Neutrik crimp tool
C
- HXBNC with the corresponding insert
or hexcrimp acc. to IEC 803-W (SW 1.7)
or squarecrimp acc. to IEC 803-2 (SW 1.6)
- Pin can also be soldered (Optional)!
Don't damage the foil!
(if existing)
D
- Straighten the pin if misaligned.
E
Insert the cable into the connector body
F
Slide the ferrule over the shield to the front
crimp
and push the cable and leading ferrule to it`s end
position until you hear a snap noise.
Pin flush to the insulator
G
Crimp the ferrule with the tool
(For best crimping-results it is recommended to use the original
Neutrik tool - HXBNC with the corresponding insert)
F
NEUTRIK AG
NEUTRIK Zürich AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
Draft. Nr.: BDA 120 Update: 09.04.2008/ 3102M1201
()
X
LI
CH
USA
UK
www.neutrik.com
E
X
T: F:
+423 /237 24 24 +423 / 232 53 93
T: F:
+41 44 / 736 5010 +41 44/ 736 5011
T: F:
+1 732/ 901 9488 +1 732 / 901 9608
T: F:
+44 1983/ 811441 +44 1983/ 811 439
II
Data subjectto change withoutprior notice. 2008NEUTRIK . ALLRIGHTS RESERVED.©
Please note:
Position the connector body
flush with the die face.
NEUTRIK
NEUTRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
Vertriebs GmbH
Ltd.Hong Kong
®
OPERATION!
G
DE / NL / AT
FR
JP
HK
CRIMP
T: F:
+49 8131 / 280 890 +49 8131 / 280 830
T: F:
+33 1 / 4131 6750 +33 1 / 4131 0511
T: F:
+81 3 / 3663 4733 +81 3 / 3663 4796
T: F:
+852 / 2687 6055 +852 / 2687 6052
Loading...