Neuro Logic Systems RFT-17 User Manual
17 inch LCD/Keyboard Rack Kit
Installation guide for the RFT-17 Line
into a 4-post 19-inch EIA cabinet
Table of Contents
Hardware Installation… …………………………………………………………………… 2
Connecting your LCD/Keyboard………………………………………………………… 5
Operating your LCD/Keyboard..…………………………………………………………. 6
Navigating the Menu.………………………………………………………………………. 8
On-Screen Display (OSD) Menus………………………………………………………… 9
Trouble Shooting Bad Image Quality…………………………………………………… 10
Specifications………………………………………………………………………………. 12
Warranty……………………………………………………………………………………… 13
Neuro Logic Systems, Inc.
02/01/05
Page 1 of 14
17 inch LCD/Keyboard Rack Kit Installation Guide
Page 2 of 14
17 inch LCD/Keyboard Rack Kit Installation Guide
Hardware Installation
Step Detail
1. Determine the vertical location for the LCD/keyboard
in the rack. Mark the location with tape or a pencil.
This product requires one rack unit (1 ¾”) of vertical
space. Mount the LCD/keyboard at a convenient
height for an average user. (Approx 44” from floor)
Ensure the bottom of the kit is properly positioned in a
rack unit
2. Measure the distance from the front rack mounting
rail to the rear rack mounting rail. (This distance will
be needed during installation of the Rear slide
mounting brackets in step 4)
Distance= _____________
Page 3 of 14
17 inch LCD/Keyboard Rack Kit Installation Guide
Step Detail
3. Remove the slides from the tray assembly. The
slides come shipped attached to the tray assembly,
the outer slide members must be removed to be
properly installed into the rack. To remove the outer
slide members, fully extend both slides to the open
position. Once extended unlock the outer slide
members by lifting up on the left side latch and
pressing down on the right slide latch. The outer
slide member can now be removed from the tray
assembly. The inner slides are left attached to the
tray assembly.
4. Adjust the rear slide mounting brackets to the proper
depth. The rear slide mounting brackets are preassembled, but may need to be adjusted to the
proper distance measured in step 2. There is
multiple screw holes in the rear slide mounting
brackets and slide rails. You can use any of these
holes. Do not tighten screws until after you install the
slides in the rack, as you may need to make small
adjustments.
Lift Up
Push Down
5. Insert nut clips into the rack mounting rails as
required. If your rack has square or round untapped
holes, you will need to use 10-32 nut clips.
Page 4 of 14
17 inch LCD/Keyboard Rack Kit Installation Guide
Step Detail
6. Attach the left slide rail assembly to the rack
mounting rail by using (6) #10-32 x ½” screws for the
front and rear slide mounting brackets. Repeat for
the right slide rail assembly.
7. Tighten the screws that attach the rear slide mount
bracket to the outer slide member. (From step 4)
(4X)
8. Extend the slides from the rack.
9. Install the LCD/keyboard assembly into the rack. Lift
the tray assembly and approach the rack with the
rear of the tray facing the rack enclosure. Align the
tray assembly with the slide rails in the rack.
Carefully assemble the two slide members together.
Push the tray assembly in until the slides latch
together. Release the lock mechanisms as shown in
step 3 in order to slide the tray assembly completely
closed.
Page 5 of 14
Loading...