Neu-F NF.6501 User Manual

AIR INTAKE KIT

2012-14 Fiat 500 Abarth
PART # NF.6501

INSTALLATION INSTRUCTIONS

PART LIST: 1 – Silicone Hose 1 – Aluminum Intake Tube 1 – Air Filter
2 - #32 hose Clamp 2 – Vent Line Connector 1 – M6 x 40mm Flange Bolt
2 – Wire Tie 1 – 15” x ½” Hose 1 – Vinyl Cap
1- Plastic Union

TOOLS REQUIRED: 1 – 10 mm Socket 1 – 8mm Nut Driver 1 – Screwdriver
1 – Spring Clamp Pliers

1. Disconnect the (2) vent lines attached to the

turbo inlet pipe.

2. Loosen hose clamps at turbo and air filter box

then remove turbo inlet pipe.

5. Disconnect valve cover breather hose.

6. Install the (2) vent line fittings and hose clamp

onto silicone hose then attach to turbo.

3. Using a screwdriver disconnect inlet duct from

air filter box.

4. Lift air filter box off rubber mounts to remove.

7. Using 10 mm socket, unbolt oil filler support

bracket.

8. Install hose clamp onto silicone hose, insert

supplied intake pipe into hose then mount on
top of oil filler support bracket using supplied
M10x40mm bolt.

neuf • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX

www.neu-f.com

9. Attach vent lines and tighten hose clamps.

14. Install lower air filter box onto rubber mounts

making sure vent hose is not being pinched off.

10. Attach supplied plastic union and ½” hose to

original valve cover breather hose from air filter
box.

11. Route vent hose as pictured and wire tie to hard

plastic vent line as pictured.

15. Connect front air intake duct.

16. Install NEUF filter and original air filter box lid.

12. Cap port on air filter box using supplied vinyl

cap.

13. Unscrew air filter lid and remove filter.

17. Re-attach breather hose support to air box lid.

18. Double check complete installation.

©Copyright 2013 NEUSPEED® All rights reserved.

Reproduction in whole or in part prohibited.

DOC.NF.2201 Rev. 11.15.2013

neuf • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX

www.neu-f.com