Page 1
NETTALK DUO WIFI SETUP GUIDE – Ad-Hoc Mode
Page 2
Step 1. Power up the DUO Wi-Fi
a. Use the supplied USB cable and power adapter.
RESET
USB
Step 2. Press the reset button 5 times
a. To press this button, which is located next to the USB/power socket, you
need a paper clip, or similar sharp object.
USB
RESET
2
Page 3
Step 3. Look for the blinking lights
a. After a few seconds, the light on the DUO WiFi should begin blinking with three
quick orange blinks, then two longe red blinks, then repeating that pattern.
USB
RESET
USB
RESET
USB
RESET
USB
RESET
USB
RESET
Step 4: Connect to wireless network
a. On your computer, look at the list of available wireless networks. One should
start with the word netTALK- followed by four letters and numbers.
1. Example: netTALK-04ac
b. Connect to the new wireless network described above.
c. When asked for the password, type this exactly.
1. 71794a2139 (Make sure the letter a is a lower case)
3
Page 4
Step 5. Open your web browser
a. Open your web browser (Internet Explorer, Firefox, Chrome, etc) on your
computer to access your DUO Wi-Fi’s web page.
b. Enter the following numbers and dots in your Browser Address bar
1. 192.168.0.1
2. Press Enter
3. The DUO Wi-Fi’s web page should be displayed in your web browser.
Step 6. Enter your wireless router security settings
a. Now you can enter your wireless router security settings to work with your
DUO WiFi.
4
Step 7. Now view your DUO Wi-Fi’s web page even if you don’t have
an Ethernet cable connected to the device.
Loading...