Digital Notepad
10.3”
Quick Start Guide
Get to Know Digital Notepad
Strap Hole
Overview
Power Button
Power LED
Home
Micro USB Port
Return
Lets Get Started
Charge Your Digital Notepad
Use the included micro USB cable to charge your
Digital Notepad USB device or with any micro USB
wall adapter (not included)
Power On
Hold the power button for 3 seconds to turn on or
turn off your Digital Notepad.
Environmental Requirements
Operating ambient temperature: 32° to 113° F (0° to 45° C)
Non-operating temperature: 14° to 122° F (−10° to 50° C)
Controls and Navigation
From the Main Menu:
Press the Note, Reader, Calendar, and Tools
applications to access them When in Note or
Reader App:
Swipe Down from the Top of your screen to
access the control toolbar to go back to the
main menu.
When in Reader App:
Swipe the screen left and right in order to turn
pages forward or backward.
The Stylus
Using the Stylus
Write and Draw with the tip of the Stylus.
Markings are all pressure sensitive.
The“Eraser”head removes stylus strokes
and makings with a single tap.
Connecting to Wi-Fi
Digital Notepad-1234-5G
Digital Notepad- 4G
Digital Notepad- 1
Digital Notepad- 2
Digital Notepad- 3
Touch the Settings icon in the top right toolbar
Toggle Wi-Fi Switch On
Touch Wi-Fi Bar to select your Wireless network
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure
limit set forth for an uncontrolled environment and are
safe for intended operation as described in this manual.
The further RF exposure reduction can be achieved if
the product can be kept as far as possible from the
user body or set the device to lower output power if
such function is available.
Note: The country code selection is for non-US model
only and is not available to all US model. Per FCC
regulation, all WiFi product marketed in US must fixed
to US operation channels only.
Looking for more Information?
Go http://www.xxxxxx.com to know more
about your Digital Notepad.
©2018 , The Company all rights reserved.The product
logos are trademarks or registered trademarks of the
Company or its affiliates.
Warranty
The company warrants to the original end user customer that its
The company -branded products are free from defects in material
and workmanship. Any claim alleging that any product fails to
conform to the foregoing warranty may be made only by the
customer who purchased such product and only while such
customer owns such product. Subject to the conditions and
limitations set forth below, The company will, at its option, either
repair or replace any part of its products that prove defective by
reason of improper workmanship or materials. Repaired parts or
replacement products will be provided by The company on an
exchange basis, and will be either new or recertified. All recertified
products have been tested to ensure that they are functionally
equivalent to new products.
This limited warranty covers only repair, replacement, refunds or
credit for defective The company-branded products. The company
is not liable for, and does not cover under warranty, any damages
or losses of any kind whatsoever resulting from loss of, damage to,
or corruption of, content or data or any costs associated with
determining the source of system problems or removing,
servicing or installing The company products. This warranty
excludes third party software, connected equipment or stored data.
The company is therefore not liable for any losses or damage
attributable to third party software, connected equipment or
stored data.
This limited warranty does not cover any damage to the product
that results from improper installation, accident, abuse, misuse,
natural disaster, insufficient or excessive electrical supply,
abnormal mechanical or environmental conditions, or any
unauthorized disassembly, repair or modification. This limited
warranty shall not apply if: (i) the product was not used in
accordance with any accompanying instructions, or (ii) the
product was not used for its intended function. This limited
warranty also does not apply to any product on which the original
identification information has been altered, obliterated or removed,
that has not been handled or packaged correctly, that has been
sold as second-hand or that has been resold contrary to U.S. and
other applicable export regulations.
Loading...