9.7” Digital Signage
User Manual
The contents of this manual will be modified without further notice.
The operation temperature for the product is between 10℃~40℃.
Operating or recharging in an environment with a temperature over 40℃ might cause
the system to malfunction. However, this should be considered a normal phenomenon.
Please do not operate under extreme temperatures.
Model: S97407
Content
Preface ............................................................................................................................................................................ 2
Safety Precautions ..................................................................................................................................................... 4
Package Content ......................................................................................................................................................... 5
Product Introduction ................................................................................................................................................ 6
Overview ................................................................................................................................................................... 6
Charging the battery ............................................................................................................................................. 8
Product Specifications .............................................................................................................................................. 9
1
Digital Signage User Manual
Preface
We appreciate your purchase the digital signage of the Sable.
Please read all instructions thoroughly for a full understanding of the products’ features.
Note:
The illustrations and images used in the manual are for reference only and may differ
from the actual product.
2
Digital Signage User Manual
Federal Communications Commission (FCC) Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user
body or set the device to lower output power if such function is available.
Note: The country code selection is for non-US model only and is not available to all US model.
Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
USA- Appliance Efficiency Compliance
3
Digital Signage User Manual
Safety Precautions
Select the install location must be cautiously. Sable will not bear any responsibility if the
user does not follow the correct device installing procedure.
Do not drop, puncture or disassemble the device; otherwise the warranty will be voided.
Do not remove or replace the battery. Only well trained service personnel are allowed to
disassemble/install the internal components.
4
Digital Signage User Manual
Package Content
9.7” Digital Signage
USB Cable
5
Digital Signage User Manual
Product Introduction
Buzzer
NFC Sensing Area
Function button
(Defined by
customer)
Overview
Front View
Rear View
6
Digital Signage User Manual
Bottom View
Key Type
Description
Power button
Hold the power button for 5 seconds to turn on or turn off the device
Wi-Fi Setting
Press to trigger Bluetooth for Wi-Fi setting
BT Pairing
Reserved
Reset
Insert a stretched paperclip or a small pin into the hole and press it for a few
seconds to reset the device
Power button
Bluetooth Pairing
Reset
Micro USB Port
(Support charging and data
transmission)
Right View
Wi-Fi Setting
7
Digital Signage User Manual
Charging the battery
Use the included micro USB cable to charge digital signage device or with any micro USB wall
adapter (not included).
8
Digital Signage User Manual
Product Specifications
Model
S97407
Dimension (L x W x H)
247.3x 196.5x 17.7 mm
Display
9.7” e-paper display
Color: Black/White/Red Color
Resolution
1200x 825 (pixel)
Connection
Wi-Fi
2.4GHz IEEE 802.11 b/g/n
BLE
Bluetooth Low Energy (BLE) 4.0
Zigbee
2.4GHz
NFC
NFC Reader
Flash Memory
8GB
USB
Micro USB
Battery
Li-ion Polymer Battery 3.8V with 3,035mAh
Operating Temperature
10℃~ 40℃
9
Digital Signage User Manual
Loading...