10-Gigabit/Multi-Gigabit Ethernet Smart Managed Plus Switches Data Sheet
XS512EM/XS724EM
Unlock your Network Potential with 10-Gigabit/
IN WEB/SMART SWITCHES
†
In Worldwide Market Share
according to IHS Infonetics, December 2016
Multi-Gigabit 5-Speed Networking Switches
Revolutionary 5-speed 10-Gigabit/Multi-Gigabit technology built in
the NETGEAR multi-speed switches allows your devices to speed past
the Gigabit barrier.
With the growth of virtualization, flash Storage, 4K videos , video
streaming and IP surveillance, SMB networks need to extend beyond
1 Gigabit barrier. The 10-Gigabit/Multi-Gigabit Smart Managed Plus
series from NETGEAR presents the right solution for this requirement;
delivering unprecedented 10-Gigabit/Multi-Gigabit bandwith at an
aordable cost.
Each port automatically detects which speed is needed by the
connected device and provides the adequate speed. As opposed to
regular 10-Gigabit switches that will only provide 1-Gigabit connectivity
to any device that require less than 10-Gigabit, the XS512EM and
XS724EM gives the exact speed required, no downgrade. Also, the new
NETGEAR Multi-speed switch ports can be connected with regular Cat5E
Ethernet cables, without the need to upgrade to Cat6/Cat6A wiring,
therefore reducing wiring costs and hassle
Highlights
Hardware Highlights
• 5-speed Networking :
- XS512EM-12-port 10-Gigabit/Multi-Gigabit
- XS724EM-24-port 10-Gigabit/Multi-Gigabit
• 2 -Port SFP+ (combo) for ber uplinks
• Rack-mount or Desktop
• Internal power supply to eliminate power brick
• Active fans for whisper quiet operation
• 50°C Maximum Operating Temperature
• Compact Small Form Factor (XS512EM)
Soware Highlights
• VLAN support for trac segmentation
• Quality of Service (QoS) for trac
prioritization
• Auto “denial-of-service” (DoS) prevention
• Link Aggregation to add redundancy and
increase your network speed (Static LAC
and LACP supported)
• Loop prevention and broadcast storm
controls
• IGMP snooping v1, v2 and v3 support for
multicast optimization
• Rate limiting for better bandwidth
allocation
• Port mirroring for network monitoring
• Jumbo frame support
• Energy Ecient Ethernet (IEEE802.3az)
support for maximum power savings
• Troubleshoot connection issues via cable
test
Industry leading warranty
• LIFETIME 24/7 Technical Support
• LIFETIME Hardware Warranty*
Page 1 of 9
Page 2
10-Gigabit/Multi-Gigabit Ethernet Smart Managed Plus Switches Data Sheet
XS512EM/XS724EM
Hardware at a Glance
Model NameForm-Factor
XS512EMRackmount/Desktop12Yes2 (shared)
XS724EMRackmount/Desktop24Yes2 (shared)
10-Gig/Multi-Gig
Copper Ports
XS512EM: front
Internal Power
Supply
10G SFP+ PortsLED's
XS512EM back
• 12 x 10-Gig/Multi-Gig Copper Ports
• 2 x SFP+ Ports
• 19-inch Rackmountable
• Small Form Factor
XS724EM: front
XS724EM back
• 24 x 10-Gig/Multi-Gig Copper Ports
• 2 x SFP+ Ports
• 19-inch Rackmountable
Link/Speed/Activity/Fan
Link/Speed/Activity
• Internal PSU
• Internal PSU
Power, Port
Power, Port
Case
Material
MetalActive Fan
MetalActive Fan
Fans
Performance at a Glance
Model NameFabric
XS512EM240 Gbps 3MB
XS724EM480Gbps 3MB
Packet
Buer
Soware at a Glance
LAYER 2 FE AT U R E S
ManagementVLANsQoS
Web Browser-based GUI (HTTP),
PC-Based ProSAFE Plus Utility (PSU)
802.1Q-based, Voice
Latency
(Max Connection Speed)
10G : AVG 4.3us
5G: AVG 5.2us
2.5G : AVG 7.1us
1G : AVG 3.76us
100M: AVG 13.63us
10G : 4.16us
5G: AVG 5.3us
2.5G : AVG 7.53us
1G : AVG 3.77us
100M: AVG 13.4us
Port-based, IEEE
Port-based, IEEE
802.1p/DSCP-based
VLANS
N/A
N/A
MAC Address
Table
32K Entries
(dynamic)
32K Entries
(dynamic)
Port
Trunking
Static LAG
and LACP
Page 2 of 9
Priority
Queues
8 (WRR)128178.6 Mfpsup to 9K
8 (WRR)128240 Mfpsup to 9K
IP Multicast
Filtering
IGMP
Snooping
Multicast
IGMP Group
Rate Limiting &
Priority Queueing
YesYes Yes
Packet Forwarding
Rate (64 byte)
Jumbo Frame
Support
IEEE (802.3az) Energy
Eecient Ethernet
Jumbo Frames
(bytes)
Page 3
10-Gigabit/Multi-Gigabit Ethernet Smart Managed Plus Switches Data Sheet
XS512EM/XS724EM
Features at a glance
HARDWARE FEATURESBENEFITS
10-Gigabit/Multi-Gigabit supportEach copper interface supports 100M/1G/2.5G/5G/10G giving the exact speed required to any device
regardless of the cable that´s been used.
Active FansActive Fans make the XS512EM and XS724EM silent switches, well below oces ambient background noise.
10GBASE-X SFP+ portsProviding exibility to uplink to 10G-capable core or aggregation switches that support ber links. Backward
compatible to Gigabit ber. Support copper or ber modules.
Rackmount or desktopFlexible deployment for either rackmount or desktop placement.
SOFTWARE FEATURES BENEFITS
Port-based and 802.1Q-based VLANsSegment network into smaller groups for more secure and ecient use of network resources.
Comprehensive QoS features:
• Port-based or 802.1p-based prioritization
• Layer 3-based (DSCP) prioritization
• Port-based ingress and egress rate limiting
IGMP SnoopingFor improved network eciency on delivering multicast trac. Save cost and improve network eciency by
Link Aggregation ( Static LAG and LACP) Build up bigger bandwidth to support aggregated uplink/downlink trac or to provide redundant link(s) using
Voice VLAN The feature enables auto assignment of voice trac (based on OUI) to a special VLAN (AKA Voice VLAN);
Loop detection and auto DoS preventionDetect accidental network loops and protect against DoS attacks.
Port MirroringFor better and quicker network diagnostics and troubleshooting.
Energy Ecient Ethernet (IEEE 802.3az)For maximum power savings and reduced energy costs.
Cable TestEasily identify bad Ethernet cables.
Advanced controls for optimized network performance and better delivery of mission-critical trac such
as voice and video. Ingress and egress rate limiting allows for bandwidth shaping for mitigating network
resources constraints or for optimizing guest access bandwidth on the network.
ensuring multicast trac only reaches designated receivers without the need of an extra multicast router.
Static Manual LAGs or LACP.
allowing the assignment of special QoS parameters to that trac, giving it high priority services. Port has
to be MANUALLY assigned to be a member of the Voice VLAN.
Page 3 of 9
Page 4
10-Gigabit/Multi-Gigabit Ethernet Smart Managed Plus Switches Data Sheet
XS512EM/XS724EM
Example Application
XS512EM/XS724EM in a Business Environment
SMALL OFFICE/HOME OFFICE NETWORK DIAGRAM
10G link to
10G NAS
1G link to computer
CORE BACKBONE
2.5G link to 2.5G
gaming computer
10G fiber link
XS724EM
2.5G PoE link to
AC Wave 2 Wireless AP
Network
router
Internet
10G link to 10G
computer with a
Thunderbolt port
Cables and Speeds
The following table describes the network cables that you can use for the switch connections and the speeds that the cables
can support, up to 100 meters (328 feet).
SPEEDCABLE TYPE
100 MbpsCategory 5 (Cat 5) or higher rated
1 Gbps, 2.5 Gbps, or 5 GbpsCategory 5e (Cat 5e) or higher rated
10 GbpsCategory 6A (Cat 6A) or higher rated
Note: For speeds of 10 Gbps, if the cable length is shorter than 55 meters (180 feet), you can use a Cat6 cable.
Why the NETGEAR 10-Gig/Multi-Gig Switches are ideal for SMB?
1. 5-speed Networking Expand your network instantly and give your devices either 100Mb, 1, 2.5, 5 or
10-Gigabit automatically,
2. Security to protect the SMB networks for possible threats thanks to Auto DoS and Storm Control.
3. Visibility to identify any possible cable issues or abnormal trac behavior with cable health test and port statistics.
4. Enhanced Control to improve your network performance with VLAN, QoS and Multicast Support.
5. Reliability to assure that the SMB networks are up and running we introduced Link Aggregation and Loop Prevention to
minimize possible downtimes.
Page 4 of 9
Page 5
10-Gigabit/Multi-Gigabit Ethernet Smart Managed Plus Switches Data Sheet
XS512EM/XS724EM
Technical Specifications
PRODUCT XS512EMXS724EM
100M/1G/2.5G/5G/10G RJ-45 copper ports1224
10G SFP+ ports2 (shared)2 (shared)
Form FactorDesktop/RackmountDesktop/Rackmount
PERFORMANCE SPECIFICATION
Packet buer memory
(Dynamically shared across only used ports)
Forwarding modesStore-and-forward
Bandwidth240 Gbps480 Gbps
MAC Address database size (48-bit MAC addresses)32K
AGM732FSFP Transceiver 1000BASE-LX (Long range, single mode)
AGM734SFP Transceiver 1000BASE-T Copper RJ45 GBIC
AXC76110GSFP+ Cu (passive) SFP+ to SFP+ Direct Attach Cable 1m
AXC76310GSFP+ Cu (passive) SFP+ to SFP+ Direct Attach Cable 3m
AXM76110GBASE-SR SFP+ GBIC (OM3/OM4 Multimode)
AXM76210GBASE-LR SFP+ GBIC (Single mode)
AXM76310GBASE-LRM SFP+ GBIC (Long Reach Multimode for OM1/OM2, also compatible with OM3/OM4)
AXM76410GBASE-LR LITE SFP+ GBIC (Single mode)
* This product comes with a limited warranty that is valid only if purchased from a NETGEAR authorized reseller, and modifications to product may void the warranty; covers hardware, fans,
and internal power supplies - not soware or external power supplies; see http://www.netgear.com/about/warranty/ for details. Lifetime technical support includes basic phone support for
90 days from purchase date and lifetime online chat support when purchased from a NETGEAR authorized reseller.
** The NETGEAR OnCall 24x7 contract provides unlimited phone and email technical support for your networking product. For roducts purchased prior to 06/2014, also includes
next business-day hardware replacement.
†
NETGEAR #1 in Fixed Web(Smart)-Managed Worldwide Market Share according to IHS Infonetics Ethernet Switches Market Share and Forecast, 1Q17 Edition, Dec 2016.