Netcore NW360, NW350 User Manual

NW360

User Manual

V1.0

2009-07-15

NW350/NW360 User Manual

1

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. NETCORE® is a registered trademark
of NETCORE INDUSTRIAL CO.LTD. Other brands and product names are trademarks or
registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to
make any derivative such as translation, or adaptation without permission from NETCORE
INDUSTRIAL CO.LTD. Copyright © 2009 NETCORE INDUSTRIAL CO.LTD.

All reserved.

http://www.netcoretec.com

NW350/NW360 User Manual

2

Certifications

FCC CE.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to
operate this equipment. (Example- use only shielded interface cables when connecting
to computer or peripheral devices).

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in con

-junction with any other antenna or transmitter.
This equipment complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.

Caution!

The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.

NW350/NW360 User Manual

3

Package Contents

The following items should be found in your package:

¾ One NW350/NW360
¾ CD

¾ Quick Installation Guides

Make sure that the package contains above items. If any of the listed item are damaged or
missing, please contact with your distributor.

NW350/NW360 User Manual

4

Contents

1. INTRODUCTION.........................................................................................................................5

1.1. PRODUCT OVERVIEW .............................................................................................................5

1.2. MAIN FEATURES ....................................................................................................................5

1.3. STANDARDS ...........................................................................................................................5

1.4. WORKING ENVIRONMENT ......................................................................................................5

1.5. SYSTEM REQUIREMENT..........................................................................................................6

2. DRIVER AND UTILITY INSTALLATION..............................................................................7

3. INSTALL NW350/NW360.........................................................................................................10

3.1. NW350................................................................................................................................10

3.2. NW360................................................................................................................................12

4. SYSTEM CONFIGURATION..................................................................................................14

4.1. GENERAL .............................................................................................................................14

4.2. PROFILE ...............................................................................................................................15

4.2.1. Add.................................................................................................................................16

4.2.2. Remove ...........................................................................................................................18

4.2.3. Edit .................................................................................................................................19

4.2.4. Duplicate ........................................................................................................................20

4.2.5. Set default.......................................................................................................................21

4.3. AVAILABLE NETWORK.........................................................................................................21

4.4. STATUS ................................................................................................................................23

4.5. STATISTICS...........................................................................................................................23

4.6. WI-FI PROTECT SETUP .........................................................................................................24

5. FAQ..............................................................................................................................................26

NW350/NW360 User Manual

5

1. Introduction

Thank you for choosing this 11N NW350/NW360.

1.1. Product Overview

The NW350/NW360 is a powerful 32-bit PCI or USB 2.0 Adapter that installs quickly and
easily into PCs. The Adapter can be used in Ad-Hoc mode to connect directly with other
cards for peer-to-peer file sharing or in Infrastructure mode to connect with a wireless access
point or router for access to the Internet in your office or home network.
The NW350/NW360 connects with 802.11n networks at up to an incredible 300Mbps! And
for added versatility, it can also interoperate with all the up to 54Mbps 802.11g or 11Mbps

802.11b products found in homes, businesses, and public wireless hotspots around the country.
And in every mode, your wireless communications are protected, so your data stays secure.

1.2. Main Features

¾ Complies with IEEE 802.11b, 802.11g and 802.11n standard for 2.4GHz Wireless LAN
¾ Compliant with USB2.0 Standard.
¾ Capable of up to 128-Bit WEP, TKIP and AES
¾ Supports Windows98/ME/2000/XP/Vista
¾ Supports MIMO technology with 1 transmit and 2 receive.
¾ Lower power consumption.
¾ Easy to install and configure

¾ Support WPS

1.3. Standards

¾ 802.11b/g/n
¾ 802.11i

1.4. Working Environment

Temperature

¾ 0° to 50° C (operating),
¾ -40° to 70° C (storage)

Humidity

NW350/NW360 User Manual

6

¾ 10% to 90 % non-condensing (operating),

¾ 5% to 90% non-condensing (storage)

1.5. System Requirement

You must have at least the following

¾ A laptop computer/desktop PC with an available 32-bit PCI slot or USB
¾ At least a 300MHz processor and 32MB of memory
¾ Windows 98SE, ME, 2000, XP, Vista
¾ A CD-ROM Drive
¾ PCI/USB controller properly installed and working in the computer

¾ A 802.11n 、802.11g or 802.11b Access Point (for infrastructure Mode) or another

802.11n、802.11g or 802.11b wireless adapter (for Ad-Hoc; Peer-to-Peer networking
mode).

NW350/NW360 User Manual

7

2. Driver and Utility Installation

¾ Insert the Driver and Utility CD-ROM into the CD-ROM driver.

¾ The Wizard should run automatically, and Figure 2-1should appear. If not, click the

Start button and choose Run. In the field that appears, enter D:\autorun.exe (if ‘’D’’ is
the letter of your CD-ROM drive).

Figure 2-1

Next we use the NW360 installation steps as example. According to the NW350 installation
steps, you can commplete NW350 installing easily.

¾ Click Install Driver & Utility for Wireless USB Adapter on the Wireless Client

Configuration Utility dialogue box, and then select the installing language from the next
screen and click Next button.

NW350/NW360 User Manual

8

Figure 2-2

¾ Click Next

Figure 2-3

¾ Click Install to start installing