Netbotz NBES0313 User Manual

NetBotz® Door Switch Sensors for APC® Racks (NBES0313)

Installation Instructions

Inventory

M3 hex nut (2)

Magnet

6-32 x 5/16-in screw (4)

Switch with connected 1.57-m (62-in) door switch

sensor cable

203-mm (8-in) tie wrap (5)

Installation

Caution: Make sure you connect this sensor to a Sensor port on applicable NetBotz

products. See your NetBotz product documentation for details.

Note: You can extend the length of the sensor cable up to 30.5 m (100 ft) using the
RJ-45 coupling and standard CAT-5 cabling.

Wire clip (8)

Adhesive cable tie holder (5) RJ-45 coupling (1)

63.5-mm (2.5-in) dual adhesive
tape (2)

Front Door of NetShelter

1

®

SX Enclosure

Rear Door of NetShelter SX Enclosure

2

Customer support and warranty information is available at the APC Web site, www.apc.com.

© 2011 Schneider Electric. All rights reserved. All Schneider Electric trademarks are property of Schneider

Electric S.A.S or their subsidiaries. Other trademarks are property of their respective owners.

990-4589

9/2011