Ness TX-103R, TX-114R Installation Manual

1

Radio TRansmiTTeR seTup & opeRaTion

Ness-Takex Radio PIRs

Radio Transmitter setup and operation Rev 2.

Refer to the separate Takex manual for installation and setup of the sensors.

Product Models TX-103R Outdoor Radio PIR

TX-114R Outdoor Radio PIR

NESS RADIO FEATURES

• Transmits Ness 56 bit encrypted format.

• SUPERVISORY messages sent hourly.

• LOW BATTERY detection and
transmission.

• Ultra low current draw.

• Alarm, Low Battery and Supervision
messages (Both models).

• Tamper message (TX-114R only).

TAKEX SENSOR FEATURES

• Outdoor Radio PIR.

• Pet Tolerant to 18kg (TX-114R).

• Pointable through 180 degrees.

• Adjustable sensitivity & pulse count.

• Adjustable lux level sensor for day and/or
night operation selectable.

• 9V battery operation.

TX-103R

TX-114R

IntroductIon

2

This manual covers the setup and operation of the Ness Radio Transmitter fitted
to the TX-103R and TX-114R Radio PIRs.

For instructions on the installation and adjustment of the motion sensors, refer
to the Takex documentation supplied with each unit.

The Ness Radio Transmitter is factory-fitted inside the sensor and requires no
installation or adjustment.

The Ness Radio Transmitter is compatible with all Ness receivers and radio­enabled control panels.

Radio security features include radio encryption and an hourly supervision
signal for enhanced radio security when used with Ness control panels.

“Another innovative Ness radio product.”

TX-103R

Transmitter &
battery holder

Battery holder

Transmitter
(internal)

TX-114R

radIo transmItter

3

ALARM SIGNALS

The sensor sends an alarm signal when it alarms and a restoral signal when the
alarm resets.

A supervision signal is sent every hour. The supervision message can be used
by compatible control panels to verify the correct operation of the sensor.

A Tamper alarm is sent by the TX-114R model. (The TX-103R does not send
Tamper).

PROGRAMMING TO A RECEIVER

The transmitter sends a radio learn message on power up, (when you connect
the battery). For programming to a Ness control panel or standalone receiver
refer to the manuals for those products.

BATTERY

A single 9V battery powers the sensor and the radio transmitter.

A low battery signal is sent when the battery is low and should be replaced.
The battery status is sent every hour along with the supervision message.
Compatible Ness receivers and control panels can display low battery and
supervisory alert warnings.

TRANSMITTER TIMEOUT

Both sensors have a selectable Prohibition Timer to conserve battery life.

When the Prohibition Timer is enabled, the sensor will not re-transmit for a set
period after an alarm.

TX-103R

Prohibition Timer has two
settings, ON (1min) and
OFF.

Prohibition
Timer switch

TX-114R

Prohibition Timer has 4
settings, 10sec, 120sec,
300sec, 900sec.

Prohibition Timer
Dipswitches 2 & 3