Ness Smartbell Installation Note

Ness Smartbell Flush Mount Outdoor Phone Unit (ODP) Page 1

Ness Smartbell

Flush Mount Outdoor Phone (ODP)

Note:

1. Do not connect the ODP to the customers LAN network. It must be connected direct to the Ness

Smartbell eGateway controller.

2. Remove the dust cap from the front of the camera before use.

3. Front cover is held in position with strong magnets. Once installed it should clip off with medium

force using a small flat blade screwdriver from the edge of the cover

4. Refer the Smartbell User Manual on the eGateway CD for Installation and programming details.

Remove Dust Cap

Ness Smartbell Flush Mount Outdoor Phone Unit (ODP) Page 2

NOTE: Each Outdoor Phone / Door station must be wired direct back to the eGateway Outdoor Port
using suitable Cat5e / Cat6 Data cable. Do not connect these units to your LAN data network.

Note

: The Indoor & Outdoor ports on the eGateway
module are POE (Power over Ethernet). Therefore
Indoor / Master Room stations and Outdoor Phones /
Door Stations connected to these ports, are powered
off these ports, therefore no need to additional power
supplies.
“However If more than 2 devices are needed to be
installed you can use LAN1 and LAN 2 ports on the
eGateway, however external power supplies will be
required to power these additional modules connected
to LAN 1 & LAN 2 ports