Page 1
SDI Box Camera Quick Guide
00P5SH061ZXSEA3
The quick guide is for quick installing and connecting the SDI Box Camera. For details, please refer to the camera’s
User Manual.
System Configuration
Connector Definition
Single Board Dual Board
DIP Switch Setting
The table below shows the definition of each DIP Switch on the Camera’s Rear Plate.
Setting
Pin Definition
ON OFF
1
TV System NTSC PAL
2
Resolution 720P 1080P
3
Frame Rate 50/60 25/30
4
Reserved - -
5
Reserved - -
6
BNC ON OFF
Please kindly notice that while BNC is on, there will be no signal from SDI output
Item Definition Remark
A
PWR Power connection indication (green light)
B
AUTO IRIS Connector Auto Iris Lens connector
C
RESET Reset
D
SDI OUTPUT SDI signal output
E
↑ / ↓ / ← / → / ENTER
OSD control key
Single Board DC12V Power connector
＋
AC 24V: AC_IN 1 DC 12V: DC12V
AC 24V: GND DC 12V: GND
F
Dual Board DC12V/AC24V
－
AC 24V: AC_IN 2 DC 12V: DC12V
G
VIDEO BNC output
H
DIP Switch TV system/ Resolution/ Frame Rate Setup/BNC
1 ALARM_GND 5 T-
2 ALARM_IN+ 6 T+
3 ALARM_OUT- 7 R-
I
Alarm I/O
4 ALARM_OUT+ 8 R+
www.ness.com.au
RECOMMENDED SETTINGS
Turn OFF switches 1-6
for correct operation.
INSTALLERS PLEASE NOTE:
Dipswitch 6 must be OFF to enable SDI output
Loading...