TECH HELP: POWER FAILURE REBOOT / RESET Procedure.
Due to the sensitivity of any Digital Recorder or Computer utilizing an Hard Drive
it is vital to ensure that the system is maintained by proper power connection.
This can be achieved by providing a stable power supply ( 240VAC ).
If, Mains power is not stable and your site is affected by power black outs or
fluctuations, then it is highly recommended that you provide the EDSR system a
suitable Uninterrupted Power Supply ( UPS ). This will ensure correct and stable
operation of your video recordings to the Hard Drive and also ensure that your
investment towards an NESS CCTV system is secured, resulting in many trouble
free years of operation
.
If your system has experienced an power black-out and the system does not
resume operation, which was caused by a high voltage start up ( brown out ),
then the following procedure should be performed.
1) Turn Off the EDSR100, ( Switch at Rear of Unit ).
2) Open the Hard Drive Cover and disconnect the Hard Drive by turning
the Hard Drive Key Lock OFF.
3) Turn ON the EDSR100, wait for the LCD screen to display normal time date,
status information.
4) Turn ON the Hard Drive Lock, wait for the ( System Loading ) indication on the
Monitor to stop flashing and disappear, Now Press REC to resume normal
recording.
The System is now Reset and functioning properly.
If, this reboot procedure does not work first time, repeat all 4 steps,
If the system after repeating these steps does not reboot,
Call your NESS DEALER for Service attention.
19