NEO TELECOM GDI-EGRX600 User Manual

Q

uick Start USER

ECOROX

ECOROX Control Buttons

Models: GDI-EGRX600--610

Features &

LED Status Indicators:

’

Q

uick Start USER

ON/OFF

ON/OFF

PRESS button

once to Power

ON / OFF

Green LED
turns ON &
after a few
seconds delay
the unit beeps to
indicate power
initiated and set
ON

Bluetooth

Bluetooth

STEP 1. Find & enable

Bluetooth on your
Smartphone/
Smartdevice
STEP 2. PRESS button
once on ECOROX to
initiate Bluetooth
BLUE LED will blink
rapidly indicating ready
to pair.
STEP 3. Find
“ECOXGEAR” on your
Smartphone as a pairing

SPEAKER VOLUME

How to pair your Smartphone

SPEAKER

VOLUME

PRESS button to

( -)

( + )

or

decrease
increase

SPEAKER
VOLUME

NOTE: set your

SMARTPHONE to
maximum volume
level for best audio
performance

NOTE: 1 short b eep
tone will sound when
max vol. setting is

TRACK

SELECTION

TRACK

SELECTION

PRESS button to

select PREVIOUS
SONG track &
NEXT SONG
track

PLAY PAUSE

ANSWER

PLAY PAUSE

ANSWER

PRESS button
once to PAUSE &
PLAY a song track
and to ANSWER
Mobile CALLS

(MUST be paired
with Bluetooth)
PRESS button to

answer incoming
calls from your
SMARTPHONE.
Listen to the call e r
over ECOROX

BATTERY

INDICATOR

BATTERY

INDICATOR

Connect USB to

power source.
LED indicates
charging status.
RED: charge in
process
GREEN: full
charge complete

NOTE: LED will
blink 2 times every
30 seconds to
indicate
approximately 30
minutes of play

Q

uick Start USER

selection & select
“ECOXGEAR” to pair
with ECOROX
STEP 4. Select & play
your music!

-

reached on the
ECOROX

speakers & talk
over the built-in
Microphone on the
front of the unit

time remains

RUBBER CAP, USB POWER & AUX-IN

CONNECTIONS

 Pull tab on the rubber cap to open the back panel

compartment for access to AUX-IN & USB
CHARGING connections

 AUX-IN can be used as an optional connection to

play an audio device using a 3.5mm audio cable
connection.

Q

m

uick Start USER

USB CONNECTION & CHARGING

 Charge the built-in rechargeable battery via USB cord (included) connected to your computer OR via a USB-to-AC power

adapter.

 When connected to a power source via the USB connection on the back panel, the Battery LED on the front panel (refer to Diagra

2.) will indicate the power status. IF not connected to the charging cable, the LED will NOT indicate the power status.

 RED LED indicates charging is in progress. A GREEN LED indicates the battery is fully charged.
 The Power LED will flash 2 times quickly every 30 seconds when approx. 30 minutes of playtime remain .

NOTE: ECOROX can charge while playing audio

IMPORTANT:

IF the rubber cap is not securely closed the unit

is NOT watertight. To ensure the unit is

watertight the back panel rubber cap MUST be

closed securely.

ALWAYS CLOSE RUBBER CAP PROPERLY

to ensure unit is watertight & waterproof

In order to ensure the unit is watertight close

rubber cap & PUSH along the

RUBBER

so that the cap is flush with the

EDGE of the