Neotech Communications HGMC-11S User Manual
r
r
r
HGMC-11S
Hardened 1-port 1000Base-TX to 1000Base-FX SFP Media Converter
This quick start guide describes how to inst all and u se the Industrial Media Conve rter . This is the Media Converter of
choice for harsh environments constrained by space.
Overview
HGMC-11S is a micro-type media converter that supports external SFP modules and meets E N55 022. It is an
industrial product whose operating temperature range is -40°C to 75°C. HGMC-11S supports 1000M Ethernet port
and 1000M SFP port. The Ethernet port supports both half-duplex and full-duplex mode. HGMC-11S is the same at
the transmitter or receiver sides. Users can use different type of SFP modules (single-mod e/multi-mode fiber, 1/2
core) as needed.
This Sleek Micro-type design media converter occupies limited space and it's an ideal solution for easy installation
within most camera housings.
General
To ensure trouble free transportation and storage, all Neotech products must be thoroughly inspected, tested and
properly packed before delivery. Check the product upon receipt for any visible damage which may have been
caused during shipment.
Package Content
HGMC-11S Media Converter x 1
Power Adapt er x 1
Quick Start Guide x 1
Physical Description
Front/Rear Panel
SFP
Speed
Indicato
FX Link
Indicato
Power
Indicato
Power
Input
SPD
LINK/ACT
1 V1.0
HGMC-11S
Hardened 1-port 1000Base-TX to 1000Base-FX SFP Media Converter
Installation
SFP T ransceiver Module
You can select different SFP modul es a s required (Pl ease refer to our SFP sel ection list for th e appro priate module).
To insert/remove the SFP, the procedures are as follow:
1. On the side panel, insert the SFP module into the
SFP port until it is securely locked.
2. Connect the optical fiber (1/2 core) to the LC
connector(s) of the SFP.
3. To remove the SFP module, press down the lock
of the LC connector of the optical fiber to pull out
the fiber cable.
4. Pull down the SFP lever and hold its position. Pull
out the SFP module from the SFP port.
Setup
a) Connect the Ethernet port of the media converter to a PC or network device with a network cable.
b) Insert the appropriate SFP into the corresponding SFP port. Connect the fiber cable from the remote device
(media converter or switch) to the LC connector of the SFP.
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on, check the power
supply connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 3).
2 V1.0
Loading...