Neotech Communications GFSW-216SF User Manual

GFSW-216SF

Unmanaged Rack Mount 16-port 100Base-FX SFP + 2-port 10/1 00/100 0Base-TX Optical Ethernet Switch

This quick start guide describes how to install and use the unmanaged optical Ethernet Switches. The switches operate in a temperature range of
0 ° C to 50 ℃, and supports external SFP work. It is suitable for use to build fiber-optic Ethernet, SFP slot designed to support a variety of SFP
modules, allowing the construction of fiber-optic Ethernet more flexible.

Overview

GFSW-216SF is a 16 ports 100Base-FX SFP and 2 ports 10/100/1000Base-TX Optical Ethernet Switch.
The Switch provides SFP ports to support the use of SFP (Small Form-factor Pluggable) transceiver
module. User can chose different types of SFPs (100M only). The Switch supports 1or2 core Single mode
or Multi-mode fiber. The product operates at temperatures ranging from 0℃ to 50℃ and at 1U high is
designed to be installed in a 19” rack cabinet..

General

To ensure trouble free transportation and storage, all Neotech products must be thoroughly inspected,
tested and properly packed before delivery. Check the product upon receipt for any visible damage which
may have been caused during shipment.

Package Content

 Unmanaged Rack Mount 16-port 100Base-FX SFP + 2-port 10/100/1000Base-TX Ethernet Switch x 1
 AC Power Cord x 1

 Quick Start Guide x 1

Physical Description

Front Panel

Power

Indicator

FX LINK

SFP

SPD

RJ45

LINK/ACT

Rear Panel

AC Socket Power

Fuse

Earth Terminal

V1.0 1

GFSW-216SF

Unmanaged Rack Mount 16-port 100Base-FX SFP + 2-port 10/1 00/100 0Base-TX Optical Ethernet Switch

Installation

SFP Transceiver Module

You can select different SFP modules as required (Please refer to our SFP selection list for the
appropriate module).
To insert/remove the SFP, the procedures are as follows :

1. On the front panel, insert the SFP module into

the SFP port until it is securely locked.

2. Connect the optical fiber (1/2 core) to the LC connector(s) of the SFP.

3. To remove the SFP module, press down the lock of the LC connector of the

optical fiber to pull out the fiber cable.

4. Pull down the SFP lever and hold its position. Pull out the SFP module

from the SFP port.

Rack Installation

GFSW-216SF can be installed on a rack. The product has 4 mounting holes. Use 4 rack mount screws to
securely install the product in a 19” rack cabinet.

V1.0 2