NEO Electronics Co 55KVW User Manual

Shenzhen Neo Electronics Co., LTD

—User Manual—

Thank you for your support

Camera hardware installation

First, connect one end of the power supply to the camera port to see if the IR
lights of the camera light up.

Warning: Please use the correct power, so as not to damage the camera!

Software APP installation

Please make sure to collect the connection network (4G / WIFI), scan the
corresponding QR code of the mobile phone system
Download the phone APP installation or directly in the software store search
for "P2PIPCamHi" downloading and installation.

Note: Use the micro message scanning function to scan the above two­dimensional code need to manually click on the browser to open to
download.

Video playback

In the camera interface a Click "Video". On the Video Watch page b Click
Remote, then click on the camera you want to play back the video. After
entering the C storage schedule, select the time period you want to play back
to record

Mobile phone monitoring

1）Add the camera

First: Finding a mobile phone which has been downloaded APP icon and click
to run.

Connection method

Add a camera to the wireless network

This method is: the camera is not connected to the network cable state,
through the LAN WIFI connected to your camera (Note: this step, the initial
use to ensure that the phone connected to the wireless network).
Open the phone APP, in accordance with the following image order in order
to add the camera, as shown below:①②③④⑤⑥⑦

① ②

③ ④

Phone APP icon

Power supply

reset

⑤ ⑥

⑦ ⑧

a b c

View video playback, you can drag the playback progress bar for playback

Modify password / SD capacity query

1.Enter the interface, click the Settings button, you can see the camera
settings page, as shown

Fig 1 Fig 2

2.Click "Edit Password" to enter the interface of modifying the password.
Click "SD Card Setting" to enter the SD card setup page to check the SD card
usage, as shown in the figure below:

Alarm motion detection

1.Enter the interface, click the Settings button, you can see the camera
settings page, as shown:

Fig 1 Fig2

2.Enter the camera setup page as shown in Fig 1 and Fig 2, click the alarm
motion detection, and enter the alarm motion detection page to alarm.