NEOCONTROL US NMC010WG4 User Manual

CUBEE

NMC010WG4

doc. version - VI01

www.neocontrolglobal.com

[e-mail]

Neocontrol US LLC © 2017

Please, follow the device’s operating instructions as indicated

in this manual.

Sensitive to humidity! The device must not be exposed to
liquids or excess moisture.

Fragile. Handle your device carefully, avoiding impacts.

All rights reserved.

ENGLISH

NEO-CUB-BL
NEO-CUB-WH
NEO-CUB-DW
NEO-CUB-LW

BATTERY EXCHANGE

To turn on the Cubee device, just place 4 AA batteries.

• Open the Cubee; note the dividing line in the centre of the Cubee.

• Hold firmly each of the two Cubee sides with your both hands.

• Press slightly the corners of the Cubee, and then pull

• carefully each side of the Cubee.

• Insert the AA batteries following the polarity indicated.

• Close the Cubee.

• Do not use rechargeable batteries.

ESPAÑOL

Siga correctamente las instrucciones del manual.

Sensible a la humedad! El aparato no debe entrar en contacto
con agua o ambientes excesivamente húmedos.

Producto frágil. Cuide de su dispositivo, evitando impactos.

Recyclable product. Do not dispose into the environment.

This is a free guide and part of the product; therefore it cannot be
sold separately, copied or duplicated without written permission
from Neocontrol US LLC.

OVERVIEW

CUBEE is a wireless interface, from Neocontrol’s home

automation system. With an innovative design, it allows the
user to trigger up to four scenes. Four faces are tagged with
a unique icon that depicts a scene; turn the Cubee to face an
icon upward, and activate the desired scene.

SAFETY AND RESPONSIBILITY

Please read this guide carefully before using the product.
This product must be installed by a qualified home
automation installer. The installer must comply with
current standards and legislation in the country in which
the product is being installed, and inform his customers of
the operating and maintenance conditions of the product.
Failure to comply with the instructions herein constitues a
violation to the warranty and will discharge Neocontrol of
any and all liabilities.

FEATURES

• RTN Radio

• Trigger up to 4 scenes

TECHNICAL INFORMATION

• Power supply: 4 AA batteries

• RTN: Radio frequency 434MHz (TX)

• Low battery consumption

• Weight: 166g

• Singal Range RF: 80ft/25m

• Dimension: 80mm x 80mm x 80mm

• Storing Temperature Range: 0°C to +50°C (32°F to +122°F)

• Operating temperature: -10°C to +70°C. (14°F to +158°F)

• Humidity: +5% to 95% non-condensing

• Maximum RF signal power: 10mW

THE 4 SCENES

→ Scene 1

Producto Reciclable. No descartar en residuos generales.

Este manual es gratuito y parte del producto, por lo que no
se puede vender por separado, ni copiar sin el permiso por escrito de
Neocontrol US LLC.

PRESENTACIÓN

CUBEE es un dispositivo electrónico, y una interfaz móvil

para el comando de escenas en sistemas de automatización
Neocontrol. Cubee tiene seis caras, con cuatro figuras
distintas. Cada figura se puede asociar con una escena
predefinida, que se activa cuando la cara correspondiente
se coloca hacia arriba.

SEGURIDAD Y RESPONSABILIDAD

Lea este manual antes de utilizar el producto. Este producto
de Neocontrol debe ser instalado por un profesional
certificado de automatización residencial. Además,
la persona instalando debe cumplir con las normas y
legislaciones en vigor del país en el que el producto está
siendo instalado, e informar a sus clientes de la operación
y mantenimiento del producto. Cualquier violación a las
instrucciones contenidas en este manual constituye una
violación a la garantía y absuelve a Neocontrol de cualquier
responsabilidad.

CARACTERISTICAS

• Radio RTN

• Activa hasta 4 escenas de automatización

INFORMACIÓN TÉCNICA

• Fuente de alimentación: 4 baterías AA

• Frecuencia RTN: 434MHz (TX)

• Bajo consumo de batería

• Peso: 166g

• Rango de Señal RF: 25m

• Dimensiones: 80mm x 80mm x 80mm

• Temperatura de almazenaje: 0°C a +50°C

• Temperatura de funcionamiento: -10°C a + 70°C

• Humedad: +5% a 95% no condensada

• Máxima potencia de la señal de RF: 10 mW

→ Scene 2

→ Scene 3

→ Scene 4

LOS 4 ESCENARIOS (ESCENAS)

→ Escena 1

→ Escena 2

→ Escena 3

→ Escena 4

CAMBIO DE BATERIAS

Para hacer el cambio de baterías abra el Cubee, para esto:

• Sostenga firmemente cada lado de Cubee con ambas
manos. Presione ligeramente las esquinas del Cubee y
extraiga cuidadosamente cada lado.

• Introduzca las 4 baterías. Atención con sus polaridades.

• Al finalizar, cierre el Cubee.

• No use baterías recargables

For more information visit:

www.neocontrolglobal.com

Note: The grantee is not responsible for any changes
or modifications not expressly approved by the party
responsible for compliance. such modifications could
void the user's authority to operate the equipment.

Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV
technician for help.

Home automation
Automatización residencial
Automação residencial

Neocontrol US LLC

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.