Nemco, Inc. 56029 General Manual

Smooth Operator

Say goodbye for good to the “lift, slam, puncture and rip” can-opening
techniques that have been overstressing elbows for 100 years. The NEW
redesigned CanPRO

Think Outside the Can

Unlike conventional can openers that puncture and cut down into
the lid from the top, NEMCO’s new CanPRO cuts from the side, along
the lid’s outer seam.

• The cutter never makes contact with the inside of the can.

• No metal shavings fall into the food.

• The lid comes off clean with no jagged edges.

Seams So Smooth

As a result of NEW engineering, the compression of the CanPRO’s
cutter has been carefully fine-tuned to improve performance.

• The cutter’s new design won’t penetrate past the first layer of metal on
the lid’s seam, alleviating the potential for producing metal slivers if the
user overrotates the can.

• When the cutter runs its life cycle, it won’t cut at all, clearly
indicating it should be replaced.

Cut and Run...and Keep Running

The NEW CanPRO is specially designed to minimize downtime and costly
repairs. Remove the cutter housing assembly for easy cleaning. Then simply
clean the entire unit in the dishwasher or your 3-compartment sink.

• No more gear breakage or wear, thanks to a completely gearless handle.

• The cutter housing is a quick-change module—
switch out a used for a new with just
a pull of a pin. Keep an extra new
modular cutter on hand, and you’re
never down.

• Stainless steel and aluminum nickel­plated components translate into a long,
virtually maintenance-free life.

®

Compact runs smarter and easier and longer than ever.

inted 9/08 Pr

Pr

inted in U

.S.A.