Nemco 80650 Specifications

TONG HOLDER ASSEMBLY

Model: 80650 & 80650-1

INSTALLATION INSTRUCTIONS

INTRODUCTION

1. Please read the instructions completely before beginning installation.

2. Clean Roller Grill thoroughly before installation.

INSTALLATION

1. Be sure that the location where the Tong Holder Assembly will be installed is completely clean and free of
debris. This will ensure that the adhesive will adhere to the end frame.

2. Remove Tong Holder Back from the assembly by sliding the body up and over the mounting posts.

3. Remove the paper backing from the adhesive strip on the back side of the Tong Holder Back.

4. Attach the Tong Holder Back to the desired location on either end frame. Note that the Tong Holder
Assembly may need to be mounted in a lower position than shown below if a Guard or Divider Kit are being
used.

5. Install Tong Holder Body to Tong Holder Back by sliding it over the mounting posts located on the Tong
Holder Back. Be sure that the Body is completely seated on the mounting posts.

NEMCO FOOD EQUIPMENT

Phone: [phone] Fax: [phone] Toll free: 1-800-782-6761
www.nemcofoodequip.com

301 Meuse Argonne, Hicksville, OH 43526

1-17-2013