Nemco 69700A Operators Manual
1
BRUSHES
PAPER TOWELS
RAZOR BLADE OR
ANY SHARP OBJECT
SQUEEGEE
STEEL WOOL, SCOURING
PAD, OR ANY ABRASIVE MATERIAL
HARSH CHEMICALS
INTRODUCTION
1. Read these Operating Instructions thoroughly before using this Merchandiser. Improper use can result in equipment or property
2. The Nemco 4-Shelf Glass Bakery Merchandiser is heavy duty and is designed for commercial use.
PREPARATION
1. Remove Bakery Merchandiser from box.
2. Place on a flat surface.
3. Clean entire unit including the drawers prior to use. NOTE: See cleaning instructions below.
CLEANING
NOTE: Proper maintenance plays an important part in the life span and functioning of the unit. Failure to follow cleaning instructions
may VOID THE WARRANTY.
1. Thoroughly read all the cleaning instructions including all important information listed below in the CLEANING PRECAUTIONS.
2. Hand wash Cookie Case with a mild soap and lukewarm water using a soft, grit-free cloth to loosen any debris. NOTE: DO NOT
3. Rinse with a soft, grit-free cloth to remove cleaning residue.
4. Dry with a soft, grit-free cloth to prevent any water spotting.
CLEANING PRECAUTIONS
WARNING: Failure to follow the CLEANING PRECAUTIONS listed below WILL VOID THE WARRANTY.
NEVER use Heavy Duty Scouring Pads Green.
NEVER use Degreasers.
NEVER use abrasive or highly alkaline cleaners.
NEVER use cleaners containing strong acids, alkaline or ammonia based cleaners, or solvents like acetone, bleach, thinners, or
NEVER scrub with brushes, paper towels, steel wool, Scotch-Bite pads, scouring pads, and / or any abrasive materials.
NEVER use squeegees, razorblades or other sharp instruments to remove deposits or spots.
NEMCO 4-SHELF GLASS BAKERY MERCHANDISER
MODEL 69700A
OPERATING INSTRUCTIONS
damage, or personal injury and may void warranty.
use any of the products listed in the CLEANING PRECAUTIONS to clean the Bakery Merchandiser.
carbon tetrachloride. The use of incompatible cleaning materials will cause surface damage.
2
LOCKED
POSITION
2
2B 1 WIRE RACK
Step 3
Step 4
BACK OF MERCHANDISER
INSTALLATION OF WIRE RACKS.
1. Slide bottom (largest) wire rack inwards at an upward angle until completely in case.
2. Allow the front of the rack to pivot downwards until it locks into position. (see pic 2B)
3. Install the middle (medium size) rack on the 3
4. Install the top (smallest) rack on the 3
5. Add drawers.
rd
rd
slot above the middle rack.
slot above bottom rack.
Loading...