NELSON™ SELECTION
HASK SERIES CONNECTION KITS GUIDE
Nelson's HASK Series connection kits are Factory Mutual and Canadian Standards Association
approved or use in Class I, Division 1 hazardous areas when used with approved Nelson heating
cables.
HASK-P Power Connection Kit is suitable for connecting one
heating cable to customer supplied power wiring.
Kit Contents:
1 Approved XP Junction Box, Seal Fitting, Sealing Compound and Packing Fiber
1 Aluminum Standoff
1 Grommet
1 Power Termination with Adhesive Sealant
1 3-Point Floating Terminal Block
1 Pipe Plug
2 Stainless Steel Pipe Clamps (Specify Pipe Size)
HASK-E End Connection Kit is suitable for terminating one
heating cable in a CI, D1 heat tracing system.
Kit Contents:
1 Approved XP Junction Box, Seal Fitting, Sealing Compound and Packing Fiber
1 Aluminum Standoff
1 Grommet
1 Power Termination with Adhesive Sealant
1 3-Point Floating Terminal Block
2 Pipe Plugs
2 Stainless Steel Pipe Clamps (Specify Pipe Size)
HASK-S Splice Connection Kit is designed for connecting
two heating cables in an in-line splice configuration.
Kit Contents:
1 Approved XP Junction Box
2 Seal Fittings, Reducers, Sealing Compound and Packing Fiber
2 Cable Entry Seals with Grommets
2 Power Terminations with Adhesive Sealant
1 3-Point Floating Terminal Block
1 Pipe Plug
2 Stainless Steel Pipe Clamps (Specify Pipe Size)
HASK-T Tee Connection Kit is designed for connecting three
heating cables in a tee splice configuration.
Kit Contents:
1 Approved XP Junction Box
3 Seal Fittings, Reducers, Sealing Compound and Packing Fiber
3 Cable Entry Seals with Grommets
3 Power Terminations with Adhesive Sealant
1 3-Point Floating Terminal Block
3 Stainless Steel Pipe Clamps (Specify Pipe Size)
NELSON™ SELECTION
HASK SERIES CONNECTION KITS GUIDE
Nelson’s HASK Series connection kits include all components necessary to complete the
installation of Nelson’s full line of Class I, Division 1 heat tracing cables. The selection tables below
allow for the proper specifying of the complete connection kit assembly (example: HASK -
HASK -
SPECIFY PIPE SIZE
3
12
20
.75 – 2.5
3.0 – 10.0
12.0 – 20.0
P
E
S
T
SPECIFY KIT CONFIGURATION
Power Connection
End Connection
Splice Connection
Tee Connection
Nelson Heat Tracing Systems products are supplied with a limited warranty. Complete Terms and Conditions may be found on Nelson's website at
www.nelsonheaters.com.
P - 12).
P.O. BOX 726 • TULSA, OKLAHOMA 74101 • 918-627-5530 • 918-641-7336 • www.nelsonheaters.com 309-SG-013
© 2004 Nelson Heat Tracing Systems 04/04
Loading...