NELSON™ HEAT TRACING SYSTEMS
LT-T TANK ADAPTER KIT INSTALLATION
FOR USE WITH PLT, ALT OR LT CONNECTION KITS INSTRUCTIONS
DESCRIPTION
The LT-T Tank Adapter Kit is for use with the
PLT, ALT or LT connection kits for mounting on a
vessel.
KIT CONTENTS
1 Tank Adapter Bracket
2 Tubes of Silicone
Tank Adapter Bracket
apply silicone here
apply silicone here
PLT - ALT LT
Tank Adapter Bracket
n To insure proper mounting of the tank adapter bracket, select a convenient location.
o Allow at least 457mm (18”) of loose heater cable for each tank adapter bracket used.
p Thoroughly clean mounting surface, approximately 6” sq., so that it is free of all foreign material.
q Apply (1) tube of silicone to each foot of the tank adapter bracket and firmly press into place.
Nelson Heat Tracing Systems products are supplied with a limited warranty. Complete Terms and Conditions may be found on Nelson's
website at
!
WARNING:
Allow 24 hours for silicone to dry before
mounting stand-off to the tank adapter bracket.
www.nelsonheaters.com.
P.O. BOX 726 TULSA, OK 74101 TEL 918-627-5530 FAX 918-641-7336 www.nelsonheaters.com
GA-1471 Rev. 4
Sheet 1 of 1
September 2005
Loading...