USER MANUAL
2
WOW MOP COMPONENTS
Spray Button
Power Button
Handle
Base
Nozzle
Reservoir
Pad Attach
(Shadowed Area)
3
CARTON CONTENTS
Measuring Cup
Adapter User Manual
WOW Dry Floor Pads WOW Wet Floor Pads
4
ASSEMBLY
Lock Catch
Aluminum Pipe
Cleaning
Pads
1. Press down the lock catch to make the aluminum pipe connect with the
handle and decorative casing.
2. Place the base on the ground and keep the joint part straight.
Note: It may take some strength to fold the movable handle.
3. Press down the lock catch and insert the installed tube into the hole of
the base.
4. Place the cleaning pads on the ground, lift the machine and place on
the cleaning pads. The cleaning pads will automatically be attached to the
machine.
5
INSTRUCTIONS FOR USE
“MAX” Line
Operating
Button
Spray Button
Power ON/OFF
Pull back the handle. After hearing a clicking
sound, the headlamp and power indicator lamp
will be lit. Bring handle to 90 degrees to turn off.
Note: The machine will automatically turn into “sleep
mode” after 2 minutes of no use and the full battery
light will twinkle. Afterwards, shutdown can be used
normally.
Adding Cleaning Solution
Open the cap of the reservoir and ll using the
measuring cup to add liquid. Do not overll.
Close the cap.
Note: Maximum capacity of the reservoir is 230mL.
Operating
Press the power button on the handle to make
the cleaning pads oscillate, and press it again
to stop.
While on, hold down the spray button to spray
cleaning solution. Release button to stop.
Notes:
•Do not operate while the mop is charging.
•The longest time of spraying is 5 seconds with
one press.
•To maintain the remote sensitivity, the interval time
should be less than one second.
6
OPERATION TIPS
Charging Port
Battery Lights
Three battery lights will show the status of the battery. 100%, 65% and 30%. 3 lights will ash
when the machine is low in battery indicating to charge immediately.
Notes:
• 3 lights on 100%
• 2 lights on 65%
• 1 light on 30%
• 3 lights ashing low battery
First Time Charging
Pull out the rubber cork and turn it until the
whole charging port is revealed. Plug the
charger into the charging port.
Note: Use the original equipment manufactured adapter.
Pad Changing
Turn the machine upside down and hold
the edge of pad and then tear off it.
Handle
Put handle in upright position to turn off.
Cleaning Pads
Machine wash pads. Best used with Nellie’s
Laundry Soda.
INSTRUCTIONS FOR USE
7
TROUBLESHOOTING
Fault
Unit is vibrating/wobbling.
Reduced spray or no spray.
Spin plates are not turning or are wobbling.
Cause
1. Mop pads are not aligned with base.
1. Reservoir may be empty.
2. System isn’t completely primed.
3. Not holding trigger to spray solution.
4. Spray tips on base clogged.
1. Mop pads are not installed properly.
2. Machine is standing upright.
Treatment
1. Realign mop pads on the base.
1. Rell reservoir.
2. Hold trigger for 10 to 15 seconds to make
sure the solution has owed to the spray tips.
3. Hold trigger continuously while using the
machine.
4. Turn power OFF. Use a pin to clean the
spray tip located at the front and center of the
machine.
1. Turn power OFF. Unplug machine and follow
instructions on page 4 for replacing mop pads.
2. Recline machine.
8
Fault
No power.
Machine is leaking.
Cause
1. Cord damage.
2. Handle not properly in place.
3. Outlet not working.
4. Fuse/breaker outlet blown.
1. Cap of reservoir is not closed properly.
Treatment
1. While unplugged, inspect the full length of
the cord for damage and refer to a qualied
technician if there is damage.
2. Remove handle and click back into body. To
remove handle:
•Hold base of machine with your foot, then
insert screwdriver into the slot beneath the cord
wrap to disengage handle tab from body.
•Use other hand to hold metal pole.
•To click handle back into body, see page 4.
3. Test outlet with a small appliance like a
cell phone charger, and use another outlet if
needed.
4. Reset the breaker.
1. Close the cap properly.
TROUBLESHOOTING
9
WARNINGS
The chart is based on the regulation of SJ/T11364
o: Means the content of the hazardous substance indicated in contained in the component is within the limits set by GB/T26572.
x: Means the content of the hazardous substance indicated in contained in the component is higher than the limits set by GB/T26572.
Hazardous Substances
Components Lead Mercury Cadmium Chromium Polybrominated biphenyl Polybrominated diphenyl ethers
(Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE)
Circuit Board x o x o o o
Metal Element o o o o o o
Monoblock o o o o o o
Dry Cell x o o o o o
Charging Battery x o o o o o
10
IMPORTANT SAFETY INSTRUCTIONS
Usage
Only for home use.
Please remove large particles or substances from
the oor before using. This product is not for
sweeping or vacuuming.
In case of jam caused by small objects, please
power off before removing the objects.
Do not let children use the mop as a toy.
Use a rag to clean the mop when it’s powered
off.
Use caution when waxing wooden oors.
Battery & Charging
Do not use charger and charging batteries
provided by any third parties.
Do not self disassemble or remodel the battery
and charger.
Keep the charger away from heating sources like
radiators.
Do not touch the charger with wet cloths
or wet hand.
Please send the used batteries for recycling by
certied organizations.
If there is any damage to the cable please stop
using and contact customer service or change
the cable at the nearest service centre.
TECHNICAL PARAMETERS
Name Parameters
Battery 2000 mAh
Voltage Rating 12 V
Rated Power 35 W
Power Charger Voltage 12.6 V
Charging Time 3 - 5 h
NELLIE’S
114–2455 Dollarton Highway
North Vancouver, BC V7H 0A2
888.984.7471 nelliesclean.com
Made in China
11
Loading...