NEC V552 Installation and Setup Guide

NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Contents:
Rear Optional Table Top Stand Dimensions Optional Speaker Dimensions Display with Optional Wall Mount Kit Input Panels Control Codes Page 8
Product Description:
Type: LCD Display Resolution: 1920 x 1080 Dimensions without stand: 49.2” (W) x 28.4” (H) x 2.5” (D) Aspect Ratio: 16:9 Dimensions with stand: 49.2”(W) x 29.8”(H) x 13.8”(D) FCC: Class A Weight without stand: 58.0 lbs / 26.3 kg Power Consumption: 100W (typ) Weight with stand: 73.4 lbs / 33.3kg BTU’s: 341.21 BTU/hour
NOTES:
This document is intended to be used as a reference guide to supply useful information for a design or installation. It is not
intended to be a step-by step procedure for installation.
Any ceilings or walls must be strong enough to support the monitor and the installation must be in accordance with any local
building codes. All mounts should make secure contact to wood studs.
4:3 sources can be displayed on the 16:9 screen in either normal aspect ratio with bars on the left or right, or stretched horizontally
to fill the screen using the menus (see “Aspect Modes” in menus and user manual).
Distances are in inches, for millimeters multiply by 25.4.  Distances may vary ±5%.
Tilt Angle and Rotation:
Below is the maximum angle the monitor can be tilted. Note that the monitor can only be tilted in either landsc ape or portrait
orientation.
CL OCK WISE ROTATION ONLY MAXIMUM TILT ANGLE
www.necdisplay.com V552 Page 1 of 8
Page 1 Page 2
Page 4 Page 5 Page 6 Page 7 Page 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Ventilation Recommendation (all models):
Dimensions below are minimum recommended for proper ventilation.
10cm
(4in.)
NOTE: The ventilation space should not be covered or closed off at the front of the opening. If for some reason the opening needs to be
covered, other means of ventilation will need to be incorporated into the design. Contact NEC for design revie w and recommendations.
www.necdisplay.com V552 Page 2 of 8
Operating temperatures: Landscape: 5-40 C, 41-104 F Portrait: 5-40 C , 41-104 F
10cm (4in.)
10cm (4in.)
10cm (4in.)
10cm (4in.)
10cm (4in.)
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Display dimensions:
www.necdisplay.com V552 Page 3 of 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Display dimensions (cont.):
www.necdisplay.com V552 Page 4 of 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Table Top Stand Dimensions (ST-4620):
www.necdisplay.com V552 Page 5 of 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Optional Speaker Dimensions including holder (SP-RM1):
www.necdisplay.com V552 Page 6 of 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Dimensions with Optional Wall Mount Kit (WMK-3257):
www.necdisplay.com V552 Page 7 of 8
NEC Display Solutions of America, Inc.
V552 Installation Guide
55” LCD Display Rev 1.0
Input Panel:
Bottom
Side
Control Codes:
NOTE: Contact your NEC rep for codes not listed. NOTE: Use a cross/reverse/null modem cable.
Cable Connection
Communication Protocol:
Interface: RS-232C Parity: None Communication: Asynchronous Stop Bit: 1 bit Baud Rate: 9600 bps Communication Code: He x Data Length: 8 bits PC Control Connector (D-Sub 9Pin)
NOTE:
If so desired, jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (RxD), 3 (TxD) and 5 (GND).
www.necdisplay.com V552 Page 8 of 8
Loading...