NEC V463-TM Installation and Setup Guide
NEC Display Solutions of America, Inc.
V463-TM Installation Guide
46” LCD Display Rev 1.0
Contents
Product Description and Notes Page 1
Tilt Angle and Rotation
Ventilation Recommendations, Touch Driver Setup
Display Dimensions
Front, Top, Right, Left, Bottom Page 3
Rear
With stand Page 5
Table Top Stand Dimensions
Optional Speaker Dimensions
Optional Speaker Dimensions
Optional Wall Mount Dimensions (WMK-3255S)
Input Panel, Control Codes
Product Description
Type: LCD Display Screen Surface: Anti-Reflective Protective Glass
Resolution: 1920 x 1080 Dimensions without stand: 43.1”(W) x 25.6”(H) x 3.2”(D)
Aspect Ratio: 16:9 Dimensions with stand: 43.1”(W) x 27.0”(H) x 13.8”(D)
FCC: Class B Weight without stand: 62.0 lbs
Power Consumption: 85W (typ) Weight with stand: 66.1 lbs
BTU’s: 290.03 BTU/hour (typical)
NOTES:
This document is intended to be use d as a reference guide to supply useful information for a design or installation. It is not
intended to be a step-by step procedure for installation.
Any ceilings or walls must be strong enough to support the monitor and the installation must be in accordance with any local
building codes. All mounts should make secure contact to wood studs.
4:3 sources can be displayed on the 16:9 screen in either normal aspect ratio with bars on the left or right, or stretched horizontally
to fill the screen using the menus (see “Aspect Modes” in menus and user manual).
Distances are in inches, for millimeters multiply by 25.4.
Distances may vary ±5%.
Tilt Angle and Rotation
Below are the maximum angles that the monitor can be tilted in either landscape or portrait orientation.
CLO CKWISE ROTATION ONLY MAXIMUM TILT ANGLE
www.necdisplay.com V463-TM Page 1 of 10
Page 1
Page 2
Page 4
Page 6
Page 7
Page 8
Page 9
Page 10
NEC Display Solutions of America, Inc.
V463-TM Installation Guide
46” LCD Display Rev 1.0
Ventilation Recommendations (all models)
Dimensions below are minimum recommended for proper ventilation.
NOTE:
The ventilation space should not be covered or closed off at the front of the opening. If for some reason the opening needs to be
covered, other means of ventilation will need to be incorporated into the design. Contact NEC for design revie w and
recommendations.
Touch Driver installation
o In order for the touchscreen to properly work, the source computer needs to be connected to the
display via provided USB A to B cable. This connection on the screen is on the upper back right
side. See image to the right.
o When plugging in the USB A to B cable from a Windows 7 or XP source computer to
V463-TM, touch screen should react and act as a HID device,
automatically downloading all touch driver information.
o USB plug-in is located on the upper portion of the left side of the display.
www.necdisplay.com V463-TM Page 2 of 10
NEC Display Solutions of America, Inc.
V463-TM Installation Guide
46” LCD Display Rev 1.0
Display dimensions
-C- -C-
www.necdisplay.com V463-TM Page 3 of 10
Loading...