NEC FE2111SB User Manual
MultiSync FE2111SB
User’s Manual
Index
Declaration..................................English-1
Safety Instruction ........................English-2
Warning.......................................English-2
Caution........................................English-2
Contents......................................English-3
Quick Start ..................................English-4
Controls.......................................English-5
Recommended use.....................English-8
Specifications........................... English-10
Features....................................English-11
Monitor T roub leshooting............English-12
TCO’99......................................English-13
Declaration
English
Declaration of the Manufacturer
We hereby certify that the colour monitor
MultiSync FE2111SB is in compliance with
Council Directive 73/23/EEC:
– EN 60950
Council Directive 89/336/EEC:
– EN 55022
– EN 61000-3-2
– EN 61000-3-3
– EN 55024
and marked with
NEC-Mitsubishi Electric Visual
Systems Corporation
4-13-23, Shibaura,
Minato-Ku
Tokyo 108-0023, JAPAN
VCCI Statement
English-1
Safety Instruction
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT
USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS
THE PRONGS CAN BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
CA UTION
RISK OF ELECTRIC SHOCK • DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause
electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit.
This symbol alerts the user that impor tant literature concerning the operation and maintenance of this unit
has been included. Therefore, it should be read carefully in order to avoid any problems.
Canadian Department of Communications Compliance Statement
DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CSA C22.2 #950.
FCC Information
1.Use the attached specified cables with the MultiSync FE2111
reception.
(1) Please use the supplied power cable or equivalent to ensure FCC compliance.
(2) Shielded video type signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
2.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user
may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve RadioTV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No.
004-000-00345-4.
No user serviceable parts inside. Do not attempt to modify this equipment. If modified, your authority to operate this equipment might
be voided by FCC.
SB
colour monitor so as not to interfere with radio and television
ENERGY STAR® is a U.S. registered trademark. All other brands and product names are trademarks or registered trademarks of
their respective owners.
As an ENERGY STAR Partner, NEC-Mitsubishi Electric Visual Systems Corporation has determined that this product meets the
ENERGY STAR guidelines for energy efficiency.
The ENERGY STAR emblem does not represent EPA endorsement of any product or service.
All other trademarks mentioned in this manual are the property of their respective owners.
English-2
Contents
Your new MultiSync FE2111SB monitor box* should contain the following:
• MultiSync FE2111
•Power cord
• Video Signal Cable (VGA - VGA)
• User’s Manual
• Sales Office List
• CD-ROM:
Includes complete User’s Manual in PDF format and Windows related files (INF file and colour profile). To see the complete
User’s Manual, Acrobat Reader 4.0 must be installed at your PC.
SB
Monitor with tilt/swivel base
M
ultiS
ync
User’s Manual
FE
2111
S
B
English
Sales Office List
Video Signal Cable
Power Cord
(VGA –VGA)
* Remember to save your original box and packing material to transport or ship the monitor.
CD-ROM
English-3
Loading...