NEC Express5800-120Rf-2 Release Notes

System Release Notes
Express5800/120Rf-2
System Release Notes
PN: 455-0167 7-003
Proprietary Notice and Liability Disclaimer
The NEC Solutions (America), Inc. product(s) discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product. However, actual performance of each product is dependent upon factors such as system configuration, customer data, and operator control. Since implementation by customers of each product may vary, the suitability of specific product configurations and applications must be determined by the customer and is not warranted by NEC Solutions (America), Inc.
To allow for design and specification improvements, the information in this document is subject to change at any time, without notice. Reproduction of this document or portions thereof without prior written approval of NEC Solutions (America), Inc. is prohibited.
Trademarks
Windows 2003 and Windows NT are registered trademarks of Microsoft Corporation. SCO OpenServer is a trademark of Caldera Systems, Inc.
All other product, brand, or trade names used in this publication are the trademarks or registered trademarks
of their respective trademark owners.
November 200 4
Copyright 2004
NEC Solutions (America), Inc
10850 Gold Center Drive, Suite 200,
Rancho Cordova, CA 95670
All Rights Reserved
Express5800/120Rf-2
System Release Notes
The Express5800/120Rf-2 System Release Notes provide up-to-date information on your system. These notes also provide additional valuable information about your system that was not included in the user’s guide.
Please read these notes in their entirety.
CONTENTS
Introduction ............................................................................................................................................3
General Comments.......................................................................................................... .......................3
Advisories...............................................................................................................................................3
EXPRESSBUILDER .........................................................................................................................3
Documentation Errata.............................................................................................................................4
Lithium Battery Warning...................................................................................................................4
Installation Site ..................................................................................................................................4
User's Guide Part Numbers................................................................................................................4
nec
Introduction
These System Release Notes cover the following topics:
General Comments Advisories
General Comments
The following general comments apply to this server.
Versions of the Network Operating Systems tested and recommended are:
Microsoft Windows
Microsoft WindowsSCO OpenServer
Advisories
EXPRESSBUILDER
The following advisories apply to EXPRESSBUILDER.
Windows 2003 must be installed using EXPRESSBUILDER Express Setup
to take full advantage of NEC specific software for your server.
Note: This advisory does not apply if your operating
system was preloaded at the factory.
If you already have an operating system installed when creating a
maintenance partition, EXPRESSBUILDER will warn you of the existing partition. If you want to preserve the installed operating system, do not create the maintenance partition or the existing operating system will be overlaid by the maintenance partition.
®
2003
®
2000 and NT© 4.0 is not supported.
is not supported.
The Administrator Menu in the System Information Management segment
of the Offline Maintenance Utility is accessible only by NEC authorized service representatives.
EXPRESSBUILDER operates in floppy emulation mode. The emulated
floppy drive portion of your system CD-ROM is designated Drive A and the remaining portion(s) of the CD-ROM is designated Drive Q. Your system diskette drive is Drive B. After creating the Off-line Maintenance Utility diskette, EXPRESSBUILDER prompts you to remove the diskette from Drive B. At this prompt, remove the diskette from your diskette drive.
Express5800/120Rf-2 System Release Notes 3
D
)
y
L
Documentation Errata
Lithium Battery Warning
There is danger of an explosion if the battery is incorrectly replaced.
Replace the battery only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to the manufacturer’s ins tructions.
Installation Site
The installation site must be clean, dust-free, and well ventilated. All
ventilating openings must be kept free of obstructions. Keep the serv er away from sources of heat, vibration or physical shock.
User’s Guide Part Numbers
Part numbers referred to in the Express5800/120Rf-2 User’s Guide may
have changed since the guide was written. Some part numbers may no longer be offered. Contact your NEC sales representative for more information.
User Guide Part Number Current Part Number
Cable Arm
N8143-52F Not offered
isk Drive
N8150-161F Not offered N8150-162F 062-02012-000 / 050-02012-000 (Ultra 160 N8150-163F 062-02013-000 / 050-02013-000 N8150-164F 062-02150-000 / 050-02150-000 N8150-165F Not offered N8150-171F 062-02313-000 / 050-02313-000 N8150-172F Not offered
SCSI Controller
N8103-56F Not offered
RAID Arra
N8103-80F 062-02284-000 / 050-02284-000 N8103-81F 062-02283-000 / 050-02283-000
AN Controller
N8104-80 Not offered N8104-86 Not offered N8104-88 Not offered N8104-103 062-02127-000 / 050-02127-000 N8104-104 Not offered N8104-111 ALN-0519-IN-00 / ALN-0519-00-00
4 Express5800/120Rf-2 System Release Notes
Loading...