Nebula Mars Lite, MARS Owner's Manual

Owner’s Manual

Mars Lite

51005000706 V01

www.SeeNebula.com

For FAQs and more information, please visit:

[e-mail]

[phone] (US) Mon-Fri 9:00-17:00 (PT)

© Anker Technology Co., Limited. All rights reserved.
NEBULA and the NEBULA logo are trademarks of
Anker Technology Co., Limited, registered in the
United States and other countries.
Mode: D2321

English

01

Table of Content

01  SafetyInstructions

04  What’sIncluded

04  Overview

09  GetStarted

11  Settings

12  Enjoy

15  Specifications

16  Troubleshooting

17  Notice

18  Trademarks

18  Warranty

SafetyInstructions

Read and understand all instructions before you use this device. Do not
make any changes or settings that are not described in this manual.
If physical injury, loss of data or damage is caused by failure to follow
instructions, the warranty does not apply.

Setup

• To reduce the risk of fire and/or electric shock, do not expose the
device to rain or moisture, and objects filled with liquids, such as
vases, should not be placed on the device.

• Do not place this device on soft surfaces such as tablecloths or
carpets. Otherwise the device could catch fire.

• Do not place this device in areas susceptible to excessive dust and
dirt or near any appliance generating a strong magnetic field.

• To prevent overheating, do not block or clog the ventilation openings.

• Never place this device in a confined space. Always leave enough
space around the device for ventilation.

• Protect the device against direct sunlight, heat, large temperature
fluctuations and moisture.

• When the device is running for a long period of time, the surface
becomes hot. Shut it down immediately and unplug the power cord.
Only after the device has cooled down, you can continue to operate.

• Always handle the device with care. Avoid touching the lens.

• Never place heavy or sharp objects on the device or the power cord.

• To avoid electric shock, do not disassemble.

• Use attachments or accessories specified by the manufacturer only.

• Avoid extreme vibrations. It may damage the internal components.

• Do not allow children to handle the device without supervision.

• Under the following conditions, a layer of moisture can appear
inside the device which can lead to malfunctions: a) if the device is
moved from a cold to a warm area; b) after a cold room is heated; c)
when the device is placed in a damp room. To avoid any moisture,
seal the device in a plastic bag before moving it to another room,
and wait for one to two hours before you take it out of the bag.

English

English

02 03

Power Supply

• Use only the provided power adapter.

• Power off the device before removing the power supply from the socket.

• Protect the power cord from being walked on or pinched, particularly
at plugs, convenience receptacles, and the point where they exit from
this device.

• Unplug this device during lightning storms or when unused for a long
period of time.

• Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.

• Before you make or change any connections, ensure that all devices
are disconnected from the power outlet.

• Never touch the mains cable of the mains connection with wet hands.

Hearing Safety

• To avoid hearing damage, do not listen for extended periods at high
volume. Set the volume at a safe level.

Battery

• Do not replace the built-in battery yourself. Contact an authorized
service center to replace it.

• The remote control contains coin type batteries, which can be
swallowed. Keep the batteries out of reach of children.

• Risk of explosion! Keep batteries away from heat, sunshine or fire.
Never discard batteries in fire.

• When the remote control is not used for a long period of time, remove
the batteries.

• Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.

• Batteries contain chemical substances, they should be disposed of
properly.

• Charge the device regularly. Do not store the device with a
completely discharged battery.

Cleaning

• Power off the device and remove it from the power supply before
cleaning the surface.

• Use a soft, lint-free cloth. Never use liquid, gaseous or easily
flammable cleansers (sprays, abrasives, polishes, alcohol).

• Do not use any liquid cleaning agents for cleaning the lens, to avoid
damaging the coating film on the lens.

• Wipe over the surfaces gently. Be careful that you do not scratch the
surfaces.

• Use lens cleaning paper to clean the lens of the projector.

Repairs

• Do not make any repairs to the device yourself. Only have your device
repaired by an authorized service center.

• Improper maintenance can result in injuries or damage to the device.

Class II equipment symbol

This symbol indicates that the unit has a double insulation system.

Laser Safety

CLASS 1

LASER PRODUCT

IEC 60825-1:2014. Complies with IEC 62471:2006 Risk Group 2.

Caution:

• Possibly hazardous optical radiation emitted from this device.

• Do not stare at operating beam. The bright light may hurt your eyes.

English

English

04 05

What’sIncluded

Main unit

Power Adapter Power cord

Remote control with batteries

Manual

Owner’s Manual

P1 Lite

NEBULA

Overview

1. FrontView

2

1

3

4

11

Lens

2

Handle

3

Lens cover

• Slide down to power on and
automatically adjust focus

• Slide up to power off

4

Loudspeaker

2. RearView

2

1

3

4

6

5

7

8

11

DC IN

• Connect to power supply

2

HDMI

• Connect to a playback device with HDMI output

3

USB

• Connect to a USB storage device

• Charge a USB device as a power bank

4

AUDIO OUT

• Connect to headphone or external speaker

5

Infrared Receiver

6

Air ventilation (outlet)

7

Air ventilation (inlet)

8

RESET