NCast PR-MINI Reference Manual

NCast Presentation Recorder

Streamer-Recorder

PR-MINI

www.ncast.com

408.844.9080

Installation

There are a few easy steps to get your PR-MINI Recorder and
Streamer up and running:

Unpack the unit and plug in the Micro-USB power supply, your
ethernet cable (if you will be using a wired connection) and an
HDMI monitor (if you have one). Power on the unit. Make note of
the Serial Number (needed for wireless access and administrative
access).

Initial configuration can be done via wireless. Look for a wireless
network with an SSID similar to AP-xxxxxxxxxxxx and use the
serial number of your unit as the password to sign in.
Alternatively, plug the unit into an ethernet network with DHCP
and check the attached HDMI monitor for the registered IP
address. Enter "192.168.42.1" if on wireless or the IP address if
wired and login using "admin" as the user and the "serial number"
as the password.

Proceed to the "Configuration" tab and click on the Network icon.
Configure your wireless or wired network as needed.

Go to the Quick Start page and press Start to start recording and
then Stop when you have finished.

Visit the Archives page and download your recording. You're
done!

Reboot the unit (icon in the upper right corner) and login with the
new network address.