NBS Payment Solutions 030874 User Manual
WLM-01 WLAN User Manual
Agency Certifications:
FCC ID: COL-030874
IC: 2279B-030874
HVIN: WLM-01
AGENCY STATEMENTS
:
FCC Interference Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules and Industry Canada RSS
standard(s). These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA STATEMENTS:
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be chosen so that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
This device has been designed to operate with the antenna(s) listed below
Antennas not included in this list or having a gain greater than 4.4 dBi are
strictly prohibited for use with this device. The required antenna impedance is 50
ohms. List of all Antennas Acceptable for use with the WLM-01:
1) AMCA72-2R470G-S1F from Abracon
2) ANTX200P001B24003 from Yageo
FCC/IC COMPLIANCE:
This device complies with Part 15 of the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference, including interference that may cause
undesired operation of the device.
CAUTION: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority
to operate this equipment.
OEM RESPONSIBILITIES TO COMPLY WITH FCC AND INDUSTRY
CANADA REGULATIONS:
The WLM-01 Module has been certified for integration into products only
by OEM integrators under the following conditions: This device is granted for use
in Mobile only configurations in which the antennas used for this transmitter
must be installed to provide a separation distance of at least 20cm from all
person and not be co-located with any other transmitters except in accordance
with FCC and Industry Canada multi-transmitter product procedures. As long as
the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their endproduct for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions cannot be
met (for certain configurations or co-location with another transmitter),
then the FCC and Industry Canada authorizations are no longer
considered valid and the FCC ID and IC Certification Number cannot be
used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC and Industry Canada
authorization.
Loading...