Naxa NPB-427 User Manual

IMPORTANT NOTES
INTRODUCTION
Thank you for buying our product. Please read carefully throughout these operating instructions, so you will know how to operate your
WARNING
To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid electrical shock, do not open the cabinet; refer servicing to qualified personnel only.
CAUTION
Use of controls or adjustment or performance of procedures other than those specified herein may result in hazardous radiation exposure.
DANGER
Invisible laser radiation when open and interlock failed or defeated. A void direct exposure to beam.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications made by the user while operating this equipment.
Avoid installing the unit in locations described below:
1. Places exposed to direct sunlight or close to heat radiating appliance such as electric heaters, on
top of other stereo equipment that radiate too much heat
2. Places lacking of proper ventilation or dusty places
3. Places subject to constant vibration
4. Humid or moist places
Operate all unit controls, bottoms and switches as instructed in manual. Before turning on the power for the first time, make sure that the power cord is properly installed Store your tapes or CD in a cool area to avoid damage from heat.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO DOT REMOVE PLASTIC
UNIT COVER (OR BACK CABINET). THERE ARE NO USER SERVICEABLE PARTS INSIDE, IF UNIT NEEDS SERVICE, PLEASE TAKE THIS UNIT TO QUALIFIED SERVICE PERSONNEL ONLY
WARNING: Remove batteries if they become exhausted or if you know that this unit will not be used
again after a long period of time The incorrect use of batteries can cause electrolyte leakage, which can corrode the battery compartment
or cause the batteries to burst out, therefore:
- Do not mix battery types, e.g. alkaline with zinc carbonate.
- When inserting new batteries, replace all batteries at the same time.
This Compact Disc player is classified as a Class 1 LASER PRODUCT. The CLASS 1 LASER PRODUCT label is located on the rear end exterior.
1
2
Loading...
+ 6 hidden pages