Naxa NI-3108 User Manual

Page 1
WARNING
TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
THIS APPLIANCE SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING WATER AND
THAT NO OBJECT FILLED WITH LIQUIDS SUCH AS VASES SHALL BE PLACED ON APPARATUS.
Portable FM Radio
with iPod/iPhone Dock
Model : NI-3108
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
RISK OF ELECTRIC SHOCK
Warning: To reduce the rise of electric shock, do not remove cover (or back) no user-serviceable parts inside. Refer servicing to qualified service personnel.
CAUTION
DO NOT OPEN
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
Note: Please read and follow these instructions before using your unit.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- 1 -
Page 2
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15) Grounding or Polarization – This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. Alternate Warnings - This product is equipped with a three-wire grounding-type plug, a plug having a third (grounding) pin. This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding-type plug.
17) Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.
17) The MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
18) : CLASS II apparatus with double insulation, and no protective earth provided.
- 2 -
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. – Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- 3 -
Page 3
LOCA TIO N OF CONT ROLS
1 POWER Button 11 Speaker 2 SKIP+/TUNE+ 3 PLAY/PAUSE/M+ Button 13 Video Out Jack 4 SKIP-/TUNE- Button 14 Aux-In Jack 5 VOL+ Button 15 Rod Antenna 6 VOL- Button 16 Battery Compartment 7 SOURCE Button 8 CLOCK SET/MEM Button 9 iPHONE/iPOD Docking Port
10 LCD Display
Button 12 DC In Jack
- 4 -
CONNECTING THE UNIT TO POWER
Plug one end of the AC/DC adaptor into the DC-In jack, and then plug the other end into AC wall outlet. Before switching on the unit, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the Battery Compartment Door and insert 6 pieces UM-2 "C" size batteries into the battery compartment with battery polarity as shown inside the battery compartment.
SETTING THE TIME
Before starting to set the time, make sure that the unit is in POWER OFF Mode
1. Press and hold the MEM/CLK SET button for approx. 1 second, the hour digit in the clock display will start flashing.
2. Use the SKIP+/TUNE+ or SKIP-/TUNE- button to adjust the hour.
3. When the correct hour is selected, press the MEM/CLK SET button again to enter the minute mode with minute digit flashing.
4. Press the SKIP+/TUNE+ or SKIP-/TUNE- button to adjust the minute.
5. When the correct time is selected, press the MEM/CLK SET button to store the time in the memory.
RADIO OPERATION
1. Press the POWER button to turn on the unit.
2. Press the SOURCE button to select the FM Radio mode. FM will show in the LCD display.
3. Press and hold the SKIP+/TUNE+ or SKIP-/TUNE- button for approx. 1 second, it will start to search the next radio station in the direction of the search. The search operation simply finds stations with strong signals. Stations with weak signal can only be tuned in manually.
4. Use the VOL+ or VOL- button to adjust the volume to the desired listening level.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations. For AM reception, the unit has a built-in antenna, turn the whole unit for best reception.
SAVING RADIO STATIONS IN THE MEMORY
1. Tune to the desired stations.
2. Press the MEM CLK SET button, the display will show the next memory station number and flashing.
3. Use the SKIP+/TUNE+ or SKIP-/TUNE- button to select memory number, then press MEM CLK SET button again to store the station into the memory.
4. Repeat step 1 to 3 to store more radio stations in the memory.
5. Up to maximum 20 radio stations can be stored in the memory.
TO SELECT A STORED RADIO STATION IN THE MEMORY
Press the PLAY/PAUSE/M+ button to select the next stored radio station.
- 5 -
Page 4
LISTEN TO iPOD/iPHONE WITH DOCKING CONNECTOR Warning : Turn off your iPhone/iPod before docking on the unit
1. Press and hold the POWER button to turn on the unit.
2. Press the SOURCE button to select the iPod mode. iPod will show in the LCD display.
3. Connect the iPhone or iPod to the docking connector, the iPhone or iPod will start playing.
4. Use the VOL+ or VOL- button to adjust the volume to the desired listening level.
5. Press the SKIP+/TUNE+ button to go to the next track.
6. Press the SKIP-/TUNE- button once to go back to the beginning of the track.
7. Press the SKIP-/TUNE- button twice to go back to the previous track.
8. During playing, press the PLAY/PAUSE/M+ button to temporarily pause playing. To resume, press the PLAY/PAUSE/M+ button again.
Warning : Please make sure that your iPhone or iPod is properly docked into the unit. Failure to do so may damage your iPhone/iPod.
Charging your iPod
While your iPhone or iPod is docked in the unit and the unit is connected to AC power, your iPhone or iPod will recharge until your iPhone or iPod is fully charged.
VIDEO OUTPUT TO THE TV SET
1. Connect the Video Out jack in the main unit to the Video In jack in the TV set.
2. Turn on the TV set and select AV channel.
3. Turn on the unit and select iPod mode.
4. Select the video file on your iPhone/iPod and press PLAY/PAUSE/M+ button to start playing the video file.
AUX-IN CONNECTION
1. Press the POWER button to turn on the unit.
2. Press the SOURCE button to select the LINE-IN mode. LINE IN will show in the LCD
display..
3. Insert one side of the audio cable into the Line-Out or Phone Jack on your MP3 Player or
audio device and the other side into the AUX-IN jack of the unit.
4. Turn on your MP3 player or audio device and follow its playback instructions.
SPECIFICATIONS
Frequency Range: FM 87.5 – 108 MHz
Power Supply: AC 100V to 240V ~ 50/60Hz External DC Adaptor : 5.0V 1.8A DC 6V (4 Pcs. UM2 ‘C’ size batteries)
Specifications are subject to change without further notice.
- 6 -
Loading...