UCT84 F-CAM
Front Interface for uConnect 8.4” (RB5, RE2) Systems
NTV-KIT507
3950 NW 120thAve, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760
3950 NW 120th Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760
UCT84 F-CAM
Front Camera Interface for uConnect 8.4” Systems
NTV-KIT507
BHM
Plug & Play Harness
NTV-HAR050
Note: Any remaining wires not shown here are not used for this installation!
*Compatible Dodge Charger, Journey and Chrysler 300 only.
UCT84 F-CAM Module Pin Outs
Pink 8 CAN HI (Radio side)
Output 1 (ACC out @ 1 amp)
Output 2 (Reverse out @ 1 amp)
Output 3 (12v out w/ Front DEF)*
UCT84 F-CAM Module
NTV-ASY166
VSW Power Harness
NTV-HAR066
04/09/15
NTV-DOC194
Allows video to be displayed while the vehicle is in motion and interfaces a front camera into
select uConnect 8.4” Touch screen equipped vehicles. Note: this interface is for adding only a
front camera, not front & rear at this time!
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 | P a g e
BHM
LED: When illuminated, Video 2 is
active
LEDs: When both illuminated, Video
1 is active
LEDs: When none illuminated,
factory video pass through
Video Input/Output Connector
Normally connected pairs
(When no 12v is present on either trigger)
04/09/15
NTV-DOC194
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 | P a g e