NAV-TV Tooki Mercedes Use & Care Guide

Tooki Mercedes
Bluetooth Phone Integration
For Mercedes COMAND
NTV-KIT043/112/146/288
NTV-DOC201
Welcome to Tooki !
Tooki by NAV-TV is a Bluetooth phone integration system designed specifically for your phone-ready Mercedes vehicle.
When used properly, Tooki establishes a wireless Bluetooth link between the Mercedes COMAND radio and your mobile phone, resulting in the hands-free operation of your phone.
Loaded with key features such as Phone book synchronization (phone dependent), Privacy mode, Radio keypad dial / call / hang up, and noise-canceling technology, Tooki allows for a safer driving experience while keeping the driver connected to his wireless world.
The Tooki is an extremely sophisticated product, therefore it is strongly advised that you make yourself familiar with your Tooki system and read the instructions in this manual before operating the system.
For more information, visit www.nav-tv.com
Legend
The following legend will ease your reading this manual:
Radio operation, button press
Right, Left, Up, Down Selector buttons
Talk / Hang buttons
Mobile phone operation, such as pairing
! Operation not supported by Tooki
!
Pairing
!
1. Press TEL on COMAND Radio.
2. Normally, the display of an empty signal strength bar indicates no phone connected.
3. If necessary, dial the special pairing code at bottom of this page.
4. Start the pairing procedure on your mobile phone. Make sure the Bluetooth feature is turned on. Consult your phone!s manual for
phone-specific pairing procedures.
5. Once your mobile phone discovers Tooki 0000xxxx/xxxx (last 4 digits will vary), select and pair Tooki.
6. When prompted for a passkey, enter 6888 on your mobile phone.
7. Once pairing is complete, you should see an active signal strength indicator on the COMAND Radio.
8. You may pair up to 5 different mobile phones. For information on phone selection, see the CONNECTING section.
9. Note that once a phone is paired, you must allow the Tooki to automatically connect to it. Initiating the connection from the phone
may cause unreliable operation.
Note: the following phones require a special code to be dialed from the radio prior to pairing. Please enter the code that matches your phone, then press SEND or OK.
3*330033*1 - Headset profile
3*330033*6 - Samsung E-530, E-720
3*330033*2 - Motorola IDEN 605
3*330033*7 - Samsung Z300, Z500
3*330033*3 - Sagem MyX-8
3*330033*8 - Sony Ericsson K600, K750
3*330033*4 - Samsung A9xx
3*330033*9 - Sony Ericsson P800, P900
3*330033*5 - Samsung D500
3*330033*10 - Windows CE , Mobile
Connecting
If only one phone is paired, Tooki will attempt to connect to this phone as long as the COMAND radio is active.
Up to 5 phones may be paired and selected.
If more than one phone is paired, Tooki will attempt to connect to ANY of the paired phones. Last connected phone has a priority over other paired phones, but since different phones may have different Bluetooth latencies, it is hard to predict which phone will be connected if more than one phone is present within range of Tooki. You may manually connect to a paired phone following this procedure:
Selecting a paired phone:
1. Press TEL , Then (Asterisk)
2. Select the phone you wish to connect using the UP/DOWN Buttons.
3. In this example, 5 devices: a BlackBerry 8320, BlackBerry 8830, Jack,
Mark and NAV-TV are paired, we are selecting (Sel Blackberry 8320)
4. Press the SEND or OK button on the COMAND radio.
5. Tooki will display Calling Bluetooth Selecting… and will attempt to
connect to the phone selected. Radio will resume normal operation within a few seconds.
Deleting a paired phone:
1. Highlight (Del Phonename), press SEND or OK.
2. Tooki will display Calling Bluetooth Deleting… and Radio will resume
normal operation within a few seconds.
!
NOTE:
If your phone will not connect to the Tooki, it may be because there are too many phone already paired. Delete 1 or more phones and try connecting once more.
Loading...
+ 7 hidden pages