Nav TV PCM4-CAM User Manual

BHM

Overview

Kit Content

Infrared Receiver

OSD Menu Remote

Power/CAN Harness

LVDS
Video
Cable

PCM4-CAM Interface

Wire trigger cable (optional)

06/16/16

NTV-DOC262

3950 NW 120th Ave, Coral Springs, FL 33065 TEL [phone] FAX [phone]

www.nav-tv.com [e-mail]

PCM4-CAM

NTV-KIT750

The PCM4-CAM Kit interfaces a backup camera input (with active parking lines) and 1 additional
video input (front cam, etc) to the factory media screen in the 2017 Porsche vehicles equipped
with PCM4.0, 2015+ Audi A3 and 2015+ Golf VII. Installation is performed behind the radio (disc
player).

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.

1 | P a g e

BHM

Interface Connectors

Dip Switch Settings

Dip SW: 1 2 3 4 5 6

UP

N/A

N/A

AUDI/GOLF

N/A

HIGH RES

KEEP DOWN

DOWN

N/A

N/A

PORSCHE

N/A

LOW RES

KEEP DOWN

Power/CAN Harness

Dip Switches

Note: Remove power to the unit prior to
making adjustments to the dip switches.

Video OUT
(to screen)

Video IN (from

radio)

Not Used

Wire trigger

(optional)

Infrared Receiver

Not Used

06/16/16

NTV-DOC262

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.

2 | P a g e

NTV-DOC262

Installation (Porsche)

Interface wires

Connect to car

Radio Plug

Black (Ground)

Chassis Ground

PIN 15 (Brown)

Red (Constant 12v)

Constant 12v (+)

PIN 16 (Red/Yellow)

Green (Rev 12v in)*

Reverse Lamp (+)

---

*Note: this Green wire is ONLY used if CAN

connection does not switch display to

reverse image while in reverse properly.

Installation connections remain the same for Audi and Golf. Be sure to set dip switches appropriately.

1. Remove the factory radio. Disconnect any associated harnesses and set the radio aside.

2. Grab the provided Power/CAN Harness from the PCM4-

CAM kit. Connect the following wires to the car radio’s
main power plug*:

3. Locate the factory Green (at the radio, NOT

the screen), 4-pin round LVDS video

connector that was removed from the radio
in step 1. Connect this factory plug to the
PCM4-CAM interface at the port labeled ‘VIDEO OUT’.*

4. Connect the smaller white plug

side of the provided LVDS
Video Cable to the port on
the PCM4-CAM interface
labeled VIDEO-IN.

BHM

06/16/16

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.

3 | P a g e