NAV-TV NNG-Toyota 6 (v2) Installation Guide

3950 NW 120th Ave, Coral Springs, FL 33065 TEL [phone] FAX [phone]

NNG-Toyota 6 (v2)

Navigation interface for ‘15-‘16 Toyota Sienna

NTV-KIT823

BHM

04/12/17

NTV-DOC237

NNG-Toyota 6 (v2) Kit Content

1

2

4

5

6

8

1. Navigation & Video Interface

2. Plug & Play T-Harnesses

3. XM Module extension cable (1)

4. XM Module extension cable (2)

5. XM Module extension cable (3)

6. XM Module antenna extension

7. Optional Video input cable

GPS Antenna

8.

USB Input (updates only)

9.

3

9

7

1 | Page

NNG-Toyota 6 Navigation System Installation

NNG-Toyota 6 navigation system application guide

2015 – 2017 Sienna (Pioneer Radio)

6.1” Non-APPS Radio DIP SW 1 ON/ 7” APPS Radio DIP SW 1-4 OFF

** Toyo ta 6 navigation system only compatible to vehicles listed above. Only compatible
radio is Pioneer radio with 6.1” or 7”. Please verify the radio has “P”number on front plate for
this system to install and work properly.

This system only applicable to Pioneer radio. If your radio is NOT
Pioneer radio (usually be identified with “P” number in front of
the radio number located on the radio front plate), please contact
your distributor immediately. Any damage to this installation by
wrongly attempt to install inapplicable combination will not be
warranted.

WARRANTY DISCLAIMER NOTICE! Radio removal, disassembly, installation

of Navigation Electronics, and Rad io re-assembly / re-installation is the responsibility
of the installer. It is recommended that you contact a professional installer that is
experienced with proper work methods involving electronics and knowledgeable of
specific procedures for radio disassembly, Navigation Electronics installation, and re­assembly / re-installation of the Radio Head Unit in the vehicle. INSTALLATION

DAMAGE TO THE VEHICLE RADIO HEAD UNIT IS EXPRESSLY NOT
COVERED UNDER THE PRODUCT WARRANTY.

To avoid dangerous distractions that may lead to an accident, the driver should never
operate the system while the vehicle is in motion. Before installing the product, the
seller should inform the e nd-user of proper use and compliance with the proper
instructions and all states and feder a l laws.

Before beginning your installation, familiarize yourself with the installation
instructions and the Navigation system components .

CAUTION: It is advisable to disconnect the negative battery cable for 3 minutes
before beginning installation, to avoid unintended air bag deployment. Note and
record any anti-theft radio codes prior to disconnecting.

This is a general installation guide for navigation system only. There will not be
any instruction on dash / radio removal. Please refer to Toyota service manual
for removing radio from dash.

2 | Page

NNG-Toyota 6 Navigation System Installation

The original “piggy bag” location will be utilizing for Toyota 6 navigation. The XM
radio module will be extended the relocation behind the passenger compartment box.

Remove (6) small screws as indicated Remove factory ribbon cable from socket

Carefully remove ribbon cable from socket on the chassis side

Identify the ribbon directi on the factory ribbon cable before removal

Losen these screws to make room to pass thru the factory ribbon cable

3 | Page