Nav TV NNG-Honda 3 User Manual

NNG-Honda 3

Navigation interface for New Honda Accord/Odyssey

NTV-KIT555/584

3950 NW 120th Ave, Coral Springs, FL 33065 TEL [phone] FAX [phone]

NTV-DOC225

Honda Accord 2013-2015 / Odyssey 2014-2015 Installation

1 | P a g e

This is a NEW VERSION (HONDA 3) for Honda Accord and Odyssey.
Please pay attention to this installation guide as MOST COMPONENTS
HAVE CHANGED. DO NOT MIX WITH COMPONENTS FROM
PREVIOUS VERSION AS DAMAGES MIGHT OCCUR.

WARRANTY DISCLAIMER NOTICE! Radio removal, disassembly, installation of

Navigation Electronics, and Radio re-assembly / re-installation is the responsibility of
the installer. It is recommended that you contact a professional installer that is
experienced with proper work methods involving electronics and knowledgeable of
specific procedures for radio disassembly, Navigation Electronics installation, and re­assembly / re-installation of the Radio Head Unit in the vehicle. INSTALLATION

DAMAGE TO THE VEHICLE RADIO HEAD UNIT IS EXPRESSLY NOT
COVERED UNDER THE PRODUCT WARRANTY.

To avoid dangerous distractions that may lead to an accident, the driver should never
operate the system while the vehicle is in motion. Before installing the product, the
seller should inform the end-user of proper use and compliance with the proper
instructions and all states and federal laws.

Before beginning your installation, familiarize yourself with the installation instructions
and the Navigation system components.

CAUTION: It is advisable to disconnect the negative battery cable for 3 minutes
before beginning installation, to avoid unintended air bag deployment. Note and record
any anti-theft radio codes prior to disconnecting.

Honda Navigation Add-on System General Note

1. This is a newer version (HONDA 3) for Accord and Odyssey, please check with
application list for confirmed vehicle before any work.

2. Touch panel part numbers: Accord 2013-2015 #TSACC919

Odyssey 2014-2015 #TSODY951

3. Only one (1) video connection to the side of the factory LCD screen.
DO NOT BE CONFUSED WITH THE PREVIOUS VERSION.
Power connector is connected to Radio 20-pins plug.

4. There are OPTIONAL camera input and camera power for aftermarket camera.

5. Reverse trigger wire is NOT USED for this kit.

6. AD-Key and 3.5mm Audio Out wires are NOT USED.

7. Honda factory display screen is NOT A TOUCH SCREEN. Installer needs to

remove the factory clear panel for completing the installation.

NTV-DOC225

Honda Accord 2013-2015 / Odyssey 2014-2015 Installation

2 | P a g e

Review the overall wire connections in the figure above

HONDA-3 Component list

1. GPS Module

2. Main Harness – HONDA3-20PIN **

3. Touch Panel with TP-IN – see touch panel part number for accord / odyssey

4. Display Y Cable – GVIF-03

5. Audio Switch Box

6. Video Switch Box

7. LCD Cable

8. GPS Antenna

** Please see the connection diagram in next page for extra NOT USED wires **

NTV-DOC225

1

2

3

4

6

5

7

8

9

9. Lane Departure Warning Module (optional)

Honda Accord 2013-2015 / Odyssey 2014-2015 Installation

3 | P a g e

NTV-DOC225

or - (not used)