NAV-TV MFT F-CAM Installation Manual

MFT F-CAM
Force Front Camera Module
NTV-KIT831
3950 NW 120
Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760
BHM
10/24/18
NTV-DOC298
BHM
10/24/18
NTV-DOC298
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only.
2 | P a g e
USB cable (updates)
NTV-CAB009
Overview
The MFT F-CAM module uses OEM buttons (or wire triggers) to force an added front camera on the OEM screen at any time, in any gear on SYNC 2 and SYNC 3 (8”) Ford infotainment systems. Forcing OEM rear camera with this kit is also available if desired (SYNC 2 only). NOTE: This kit will NOT
program rear camera. This module is only intended for use with an existing rear camera (or one that was added previously with NAV-TV KIT391, 392, 456 etc). NOTE: the OEM 360 surround-view camera
system is not supported with this kit.
Kit Content
DIFF Module Pin Out
MFT F-CAM
Module (KT3)
NTV-ASY256
Plug & Play T-Harness
NTV-HAR305
VSW Module (video switching)
NTV-ASY187
DIFF Module (Diff
Video Conversion)
NTV-ASY221
BHM
10/24/18
NTV-DOC298
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only.
3 | P a g e
VSW I/O Connector Pin Out
VSW Power/Trigger Pin Out
Loading...
+ 4 hidden pages