NavAtlas NA30C Installation And Owner's Manual

NA30C

INSTALLATION/OWNER'S MANUAL

AM/FM/WB receiver with Bluetooth

IP66

NA30C

Preparation

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove trim ring from unit.

• Remove 2 transit screws located on top of the unit.

• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.

• Install mounting sleeve into opening, bending tabs to secure.

• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.

• Certain vehicles may require an installation kit and/or wiring harness adapter (sold
separately).

• Test for correct operation and slide into mounting sleeve to secure.

• Snap trim ring into place.

TYPICAL DIN FRONT-LOAD MOUNTING METHOD

2

NA30C

Wiring Diagram

BRO WN/WH ITE-- --FRO NT LEFT C H

BLA CK--- -POWE R CABLE

GND(-)

REVERSE (+) REMOTE (+)

ACC (+)

BLA CK /RED ----U SB CHAR GE (ONL Y)

BLA CK--- -USB PL AYBAC K (ONLY )

FUSE

When replacing the fuse,

make sure new fuse is the

correct type and amperage.

Using an incorrect fuse could

damage the radio.

The NA30C uses one

30 amp ATM fuse located

in-line.

BRO WN/RE D---- FRONT R IGHT CH

GRA Y/WHI TE--- -REAR L EFT CH

GRA Y/RED ----R EAR RIG HT CH

BLA CK/GR EEN-- --SUB L EFT

BLA CK/GR EEN-- --SUB R IGHT

GRA Y/VIO LET-- --CAM ERA IN

BLA CK--- -DIGI TAL OUT

GRA Y/RED ----A UX IN

BLA CK--- -ANTE NNA INP UT(AM /FM )

*

**

* Rear view camera is sold separately.

** Digital output is designed to work for all amplied
Navatlas products only.

3

NA30C

Control Locations - Receiver

1. Power/Mute

2. Audio/Menu

3. Tune/Track Down

4. Tune/Track Up

5. Mode/Camera (Hold 5 seconds)

6. Select/Preset Menu

7. Preset Up

8. Play/Pause/Band

4

NA30C

General Operation

Power On/Off

Mode

Auxiliary Input

Volume

Mute

Set the Clock

12/24-hour Clock

Camera

Press to turn the unit on. Press and hold to turn the unit
off.

Press MODE to enter the Mode Menu, then press MODE or
rotate the volume knob to select between Radio, Auxiliary
Input, USB and Bluetooth modes. Modes of operation are
shown in the display.

The NA30C uses a 3.5mm connection to any external or
portable device for audio streaming. An optional extension
(model SU35) is available to mount this connection onto the
vehicle's dash for easy access. Refer to the wiring diagram
for connection instructions. Once connected, press MODE to
select auxiliary input mode.

Adjust volume using volume knob (00-46).

Press
volume knob to resume audio.

The unit will display the time on the LCD display. Clock
settings are adjusted in the General setup menu.

The clock will display 12-hour AM/PM time or 24-hour time
(22:00). Frequency spacing is adjusted in the General setup
menu.

Press and hold MODE for 5 seconds to activate Camera mode.
The screen will display an image of the connected rear view
camera (sold separately). To exit, press MODE and select any
other source.

to silence the audio. Press again or rotate the

5