Nauto N3MB User Manual

Nauto Mark Button

Nauto Device Accessory

How It Works

f drivers sense an unsafe event, they have

I
two options to use the Mark Button to save
and upload before-and-after video.

How to upload video

1x

3x

Nauto’s Mark Button.

* In case of an actual emergency,

please call 911 and follow your
company’s standard procedures.

© Nauto 2019. All Rights Reserved.

“

This is a life-saving device

that we have today.

– Michael J., Driver

Press once to simply
log the event.

Press 3 times to send
the event and a panic
alert to your manager
immediately.*

nauto.com

Compliance Statements

FCC STATEMENT

NOTE: 15.19 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

15.21 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Content:

1. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.

FCC ID:2AKJ5-N3MB

IC STATEMENT

"This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause
interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device." or "Le présent appareil
est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1) l’appareil ne doit pas produire de brouillage; 2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement." Déclaration sur l'exposition aux rayonnements RF
L'autre utilisé pour l'émetteur doit être installé pour fournir une distance de séparation d'au moins 0 cm de toutes les personnes et ne doit pas être colocalisé ou
fonctionner conjointement avec une autre antenne ou un autre émetteur.

IC ID:22237-N3MB

® Nauto 2019. All Rights Reserved. 5