Nature Power 22040 User Manual

Version 1.1

Solar Motion Light

Instruction Manual

Product Description

Congratulations on purchasing your Solar Motion Light. Please read and follow the below instructions and retain
this manual for future reference

MFG Item Number: 22040

Installation

Solar Panel

1. Choose a surface you would like to mount the solar panel.

2. Secure bracket to solar panel with screw provided as shown in Fig 1.

3. Set bracket on surface and secure in place with larger screws provided as shown in Fig 2.

4. Adjust angle of solar panel to ensure it receives optimum sunlight.

Note: For best results ensure the solar panel is installed in a location that receives maximum sunlight and is free
from shade.

Bracket may differ from that shown in Fig 1 and Fig 2

Lamp

1. Using bracket attached to the rear of the Solar Motion Light to mark where screws should be placed.

2. Ensure this is free from any cables or Electric Lines

3. Secure light to wall with screws provided.

4. Adjust the motion sensor so that it faces the area where motion is most likely to be detected.

5. Plug solar panel into the back of Solar Motion Light

Note: Lamp unit should be mounted 2 – 3 meters (6.5 – 9.8ft) from the ground to ensure motion detection is
optimised.

1

Version 1.1

Operation

1. The Solar Motion Light is equipped with an ‘On/Off’ switch marked as I and O
a. I = On
b. O = Off

2. There is a Dial located underneath the sensor. This dial will control the amount of time the Solar Motion

light will stay illuminated for once motion is detected.

3. The sensors maximum range is up to 5 meters as show in Fig 3.

Troubleshooting

If Solar Motion Light does not illuminate while switch is turned to ‘I’ (On) please observe the
following.

 Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours.
 Clean solar cells with a damp towel, Do not apply excessive pressure and avoid the use of any solvents or

cleaning agents on the solar cells.

 Ensure switch is set to ‘I’.
 Check batteries are installed correctly.
 Allow Panel to charge in direct sunlight for 4 days with the switch in the ‘0’ Position to confirm the

batteries are fully charged.

 Replace Batteries. Note: The batteries may be dead and need replacing. Although rechargeable, the

batteries included in this unit have a limited lifetime.

 Point sensor at an area with minimal light interference.

2