FLANGE
OUTLET TUBE
OUTLET NUT
INLET
NUT
INSTALLATION INSTRUCTIONS
DECORATIVE P-TRAP DR560
BEFORE YOU BEGIN
• Observe all local plumbing and building codes.
ASSEMBLE THE TRAP
1. Install drain (not included) in sink according to
manufacturer’s instructions.
2. Remove Inlet Nut and Washer from Trap.
3. With threads facing down, slide Inlet Nut and
Washer onto tailpiece of installed drain. For 1.25”
drains, use supplied Reducing Washer.
4. Slide tailpiece of installed drain into top of Trap. Note:
be inserted at least 1” (2.5cm) inside Trap. Then
hand-tighten Inlet Nut until nut is tight against Trap.
WASHER
TRAP
REDUCING WASHER
For use with 1.25” drains
CONNECT TO THE STUB-OUT
5. Slide Flange onto long side of Outlet Tube.
6. Place Outlet Tube onto Trap and in to stubout. If Outlet
Tube is too long, use a hacksaw to cut it to appropriate
length.
7. Attach Outlet Tube to Trap by tightening Outlet Nut and
Washer.
8. Attach Outlet Tube to drain stub-out with seal
and nut (not provided). Hand tighten nut to drain
9. Ensure all nuts in assembly are tightened properly.
10. Turn on main water supply, run water through
drain and check for leaks.
Loading...