National Semiconductor Sweden LSE039 User Manual

Uppgjord (även faktaansvarig om annan) -

Prepared (also subject responsible if other)

No.

Doc respons/Approved

Checked

Date

Mikael Ohlsson

Dokansv/Godk -

1 REGULATIONS

1.1 EUROPEAN COMPLIANCE

EMC, Electrical Safety and Radio EC Directive Compliance

The CE mark is affixed to this product to confirm compliance with the following European
Community Directives:

• Council Directive 1999/5/EC of the European Parliament and the Council of 9 March
1999 on radio equipment and telecommunications terminal equipment and the mutual
recognition of their conformity.

Kontr -

Users Manual LSE039 1 (4)

Nr -

Datum -

Rev File

2001-04-20

• Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of Member
States relating to electromagnetic compatibility (EMC).

• Council Directive 73/23/EEC of 19 february 1973 on the harmonization of the laws of
Member States relating to electrical equipment designed for use within certain voltage
limits.

Each of the above mentioned directives amended by

• Council Directive 93/68/EEC of 22 July 1993 on the harmonization of the CE marking
requirements.

A “Declaration of Conformity” in accordance with the relevant standards to confirm
compliance with the above mentioned directives has been made and is on file at Wireless
Solutions Sweden AB, Sundbyberg, Sweden.

1.2 FCC (US) COMPLIANCE

FCC R.F. Interference Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.

Uppgjord (även faktaansvarig om annan) -

Prepared (also subject responsible if other)

No.

Doc respons/Approved

Checked

Date

Nr -

Mikael Ohlsson

Users Manual LSE039 2 (4)

Dokansv/Godk -

Kontr -

Datum -

Rev File

2001-04-20

This equipment has been tested and found to comply with the limits for class B Digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected

• Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by Wireless Solutions Sweden AB
could void the user’s authority to operate the equipment.

1.3 EXPOSURE TO RADIO FREQUENCY RADIATION

The radiated output power of the equipment is far below the FCC radio frequency exposure
limits. Neverthless, it is advised to use the equipment in such a manner that the potential for
human contact during normal operation is minimized.

1.4 IMPORTANT SAFETY INFORMATION

1.4.1 SAFETY WARNINGS !

Interference

All wireless devices may get interference, which could affect performance.

Switch off in aircraft

Wireless devices can cause interference. Using them on aircraft is illegal.

Switch off when refueling

Do not use the wireless Compact Flash at a refueling point. Do not use near fuel or

chemicals.

Switch off near blasting

Do not use the Compact Flash where blasting is in progress. Observe restrictions, and
follow any regulations or rules.