SCXI-1371 R
This guide describes how to attach the SCXI-1371 rack-mount kit to an
SCXI-1000, SCXI-1000DC, or SCXI-2000 chassis.
ACK
OUNT KIT
-M
Introduction
You can use the SCXI-1371 rack-mount kit to mount an SCXI-1000,
SCXI-1000DC, or an SCXI-2000 chassis in a standard 19 in. rack. With
the multiposition rack-mount brackets, you can install the SCXI chassis
in one of six different positions to attain the desired front panel depth.
What You Need to Get Started
❑ SCXI-1371 rack-mount kit
Rack-mount bracket
Four 8-32 by 5/16 in. Phillips flathead screws
Four 10-32 by 1/2 in. Phillips panhead screws
Rack-mount bracket for the 4-slot SCXI-1371 chassis (with the
longer side panel)
Brace for the 4-slot SCXI-1371 chassis
Four 6-32 hex nuts
Four no. 6 lockwashers
Two 6-32 by 1/4 in. Phillips panhead screws
SCXI-1371 Rack-Mount Kit Installation Guide
❑ No. 2 Phillips-head screwdriver
❑ 5/16 in. nut driver
❑ SCXI chassis
SCXI ™ is a trademark of National Instruments Corporation. Product and company names are trademarks or trade names of their respective
companies.
371195A-01© Copyright 1994, 1997 National Instruments Corp. All rights reserved.August 1997
Installation
Refer to Figure 1 as you perform steps 1-4. The rack-mount bracket with
the longer side panel can be mounted on either side of the SCXI chassis.
Both rack-mount brackets can be mounted in one of six positions to attain
different depths. For detailed measurements of the SCXI-1000, SCXI1000DC, or SCXI-2000 chassis, refer to Appendix A, Specifications, of
the SCXI Chassis User Manual. Item numbers refer to the labels in
Figure 1.
2
3
SCXI Chassis
2
1
3
5
5
7
6
1 Rack-mount bracket with longer side panel 5 No. 6 lockwashers
2 8-32 Phillips flathead screws 6 Brace
3 6-32 Phillips panhead screws 7 6-32 hex nuts
4 Rack-mount bracket
Figure 1. SCXI-1371 Rack-Mount Kit Installation
4
2
Loading...