National Barrington Assembly Instructions Manual

Assembly Instructions

Barrington®

Attaching Bases to
Conference Tables

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.

CC AA SS EE GG OO OO DD SS

11

Figure A

Telephone [phone]
Fax [phone]
www.nationalonline.com

Part #1847145

Printed in U.S.A
© 2005 Kimball International, Inc.

Place top(s) upside down on a smooth,
solid surface. Take car to not mar the
worksurfaces. On two-piece tables, align
the three (3) leveling devices and tighten
bolts.

22

On 14’ and 16’ tables, the mounting
pads are pre-attached (Figure A). On
10’ and 12’ tables, the center mounting
pads must be installed. Place mounting
pads as shown in (Figure B). The side
of the panel base with the two (2)
T-nuts should be placed against top
panel and the T-nuts positioned toward
outside edge of top. Use twelve (12)
washers and bolts to attach the center
mounting pads.

Recommended Tools

• Screwdriver

Figure B

NOTE: 14’ and 16’ tables use four (4) panel bases.

10’ and 12’ tables use three (3) panel bases.

8’ tables use two (2) panel bases.

Package Contents Qty.

33

Remove plywood pads from the bottom
of each pedestal.

44

On 14’ and 16’ tables, place panel bases
in positions shown in (Figure C). On 10’
and 12’ tables, the panel bases on each
end are attached with six (6) washers
and bolts. The center panel base is
attached with four (4) washers and
bolts. Install the adjustable glides on
each panel base (Figure D).

Figure C

Figure D

Mounting Pads

Mounting Pads must
be installed on 10’
and 12’ tables

14’ and 16’ Tables

10’ and 12’ Tables

Assembly Instructions

Barrington®

Attaching Bases to
Conference Tables

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.

CC AA SS EE GG OO OO DD SS

55

On 8’ 14’, and 16’ tables, attach each
panel base with six (6) provided wash­ers and bolts. On 10’ and 12’ tables, the
panel bases on each end are attached
with six(6) washers and bolts. The cen­ter panel base is attached with four (4)
washers and bolts. Install the
adjustable glides on each panel base
(Figure E).

66

Carefully turn assembled table upright.

Figure D

Bolt (4 per base)

Washer (4 per base)

Center Mounting Panel

Mounting Panel

Adjustable Glide

Panel Base

Bolt (6 per base)

Washer (6 per base)