®
RI TA
Operating Manual
Rice Cooker
NRC-4(SS)W / NRC-6(SS)W / NRC-IO(SS)W
Please read this manual thoroughly before operating this unit.
This unit must only be serviced by the authorized service center.
www.naritausa.com
Pan
Location of
spatula holder
Body
Switch
-Inner lid
Toattach inner lid press onto shaft.
Out lid
- Dew collector
To remove, hold sides
and pull out. Toattach,
reverse directions.
["Rice Cook" lamp
"Keep Warm" lamp
Power onlet
AC cord plug
B
Measuring cup Rice spatula
/ "
,
i~
Spatula holder
1
~.~~ Fo"'"p"od
Steam Tray lOcups cooker
T
PRECAUTIONS
• Plug into properly wired wall outlet. Unplug when
not in use.
• Always keep pan bottom and heating plate clean
and dry. Any foreign material between them will
cause cooker to malfunction.
Foc.igomateciC Pao
Heating plate
• Do not pour or immerse the unit
in water.
2
• When pan is not in cooker, or just after cooking,
switch cannot be engaged. Do not depress by
force.
• Set unit on a stable surface. Do not expose to wa-
ter, high humidity or heat souces. Do not use pan
directly on open flame.
• During cooking, the vent would get hot and
spout out steam, do not put your hands or face
close to it. Never have any object on the outer
lid would deform and discolour.
HOW, T.O .USE
1 Measure rice with the measurina cup and wash it in a
separate bowl.
• Be sure to measure out rice precisely with the
measuring cup.
• Do not wash rice in the pan, to avoid pan bottom
from dented or deformed and to avoid uneven
contact with the heating plate that may cause mis-
cooking. It might as well affect the special coating
of the pan,
2 The scale marked on the inside of the pan is a guide
for water level with rice.
• The left of the scale measures water in liters. Put
the washed rice of the measured quantity onto
the pan. Then add water to, e.g., For one !iter of
rice, a level indicated by "1.0"
• The right of the scale measures water in cups. Put
the washed rice of the measured quantity into the
pan. Then add water to, e.g., For 4 cups full of rice,
a level indicated by "4"
cup cup
8~~O 1'0~5
14
6 0.6 3
1.0
4
0.6 0.2
3
3 Place the pan in the body
Be sure to wipe dry the outside of the pan, particu-
larly the bottom of it. Then place the pan into the
body and turn it slightly to the night and left to
make sure that it comes into close contact with the
heating plate.
4 Fit inner lid into the outer lid
Align the center hole of the inner lid with the center
pin of the outer lid, then push the inner lid in to
make the projecting side of the packing contact the
outer lid.
5 Close the outer lid
Put on and press down the outer lid until the hook
clicks into the hook catch.
Imperfect closing the lid may affect the cooking
effciency.
•••
HOW Tp CLEAN
I
t
HOW TO USE
6 Attach AC cord to cooker and plug in. Immediately
press switch. "Rice Cook" lamp tells you cooking
has started.
• If pan is not in cooker, cooking will not begin.
7 When rice is done, switch will pop up. "Keep Warm"
Lamp lights to signal "Keep Warm" function.
• "Keep Warm" function continuous until unplugged.
8 After switch pops up, leave covered for at least 15
minutes to steam rice.
Spatula holder
10 Unplug after use.
• Remove and clean dew co[lector after every use.
4
----~
Unplug before cleaning.
1 Soak pan inner [id in hot water and wash with a
sponge.
2 Wipe body with a damp cloth. Do not immerse in
water.
3 Dew collector and spatula holder should be remo-
ved and cleaned.
• Do not use abrasive cleaners or steel wool. Clean
with non-metal brush or sponge.
Stainless Steel inn.erPan~
• Soak pan in hot water for a while.
• Use a sponge to clean.
I TO KEEP COOKED RICE ~
WARM AND TASTY
• Wash rice with water quickly and thoroughly. Bran
is removed during washing.
• Using "Keep Warm" function for more than 12
hours may cause discoloration or an objectionable
odor in the rice.
• Utensils [eft in pan during "Keep Warm" may affect
rice smell and tasteo
SPECIFICATION:
NRC-4(SS)W
Rated voltage
120V 160Hz
I
Power
3S0W
I
NRC-6(SS)W
Rated voltage
120V 160Hz
I
Power
SOOW
I
NRC-l0(SS)W Rated voltage
120V 160Hz
I
Power
700W
I
I
This unit is warranted for defective materials or workmanship for one year from the
date of purchase. The warranty is valid for any manufacturing defects only. This
warranty covers operational defects incurred in normal use and does not apply in
the case of damage, abuse, mishandling, accident, or failure to follow operation
instructions. Narita shall have no responsibility for any damages incidental to
equipment and its sole responsibility shall be for the repair of replacement as
indicated, except for shipping and handling costs. There are no implies or expressed
warranties of fitness or merchantability which extend beyond the above warranty.
Note: Any unit for reimbursement or repairing should be sent back with original
complete box to the authorized service representative.
5
Loading...