
INSTRUCTIONS D’INSTALLATION
DE L’ENSEMBLE DE ROCHES DLR35
POUR UTILISATION AVEC LES ENSEMBLES ALTERNATIFS B35NG POUR LA SÉRIE HDX35
!
AVERTISSEMENT
NE PAS UTILISER DE VRAIES ROCHES DANS CET APPAREIL. LA CHALEUR LES FERA ÉCLATER.
NOTE: Se connecter numéros se trouvent sur le fond des bûches.
1. Enlevez les composants décoratifs et jetez.
2. Mettez les amas de roches en place, en vous assurant
de ne pas couvrir les orifi ces du brûleur ou le veilleuse.
7
3
3. Placez les deux bûches inférieurs sur le côté gauche
(#3) et à droite (#13) du brûleur.
13
4. Ajouter les deux bûches (#7) restants entre eux reposant
sur les bûches précédents, comme illustrée. NOTE: Si la
fl amme effl eure les médias, il est recommandé que le
poste soit ajusté loin de la fl amme pour éviter un excès
accumulation de carbone.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • (705)721-1212 • télécopieur(705)722-6031 • www.napoleonfoyers.co
5. Étendre une petite quantité de braise sur le centre du
brûleur au plus près des ports du brûleur que possible.
W415-1524 / 07.20.15

DLR35 ROCK
INSTALLATION INSTRUCTIONS
FOR USE WITH B35NG IN THE HDX35 SERIES
!
WARNING
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
NOTE: Log numbers are located on the bottom of the logs.
1. Remove all glass media and discard.
2. Place rocks around the burner making sure not to cover
any burner ports or the pilot.
7
3
3. Add the two lower logs on the left (#3) and right (#13)
side of the burner.
13
4. Add the two remaining logs (#7) resting them on the
previous logs, as shown above. NOTE: If the fl ame is
impinging on the media it is recommended that the
position be adjusted away from the fl ame to prevent
excess carbon build up.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • (705)721-1212 • fax (705)722-6031 • www.napoleonreplaces.co
5. Spread a small amount of glowing embers over the
centre of the burner as close to the burner ports as
possible.
W415-1524 / 07.20.15