Napoleon B81NL, B81PL Installation And Operating Instructions Manual
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS.
HD81
LOG BURNER
ASSEMBLY
B81NL
NATURAL GAS
1
B81PL
PROPANE
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
SAFETY INFORMATION
!
WARNING
If the information in these instructions are
not followed exactly, a fi re or explosion
may result causing property damage,
personal injury or loss of life.
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 4Y8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • ask@napoleonproducts.com
$10.00
1.22
W415-0713 / A / 11.09.10
2
TABLE OF CONTENTS
1.0 GENERAL INFORMATION 2
2.0 INSTALLATION 2
3.0 ADJUSTMENT 7
4.0 REPLACEMENTS 8
2.1 ACCESS PANEL 2
2.2 BURNER ASSEMBLY 2
2.3 BULKHEADS 3
2.4 NIGHT LIGHT™ INSTALLATION 4
2.5 HEARTH PANEL INSTALLATION 4
2.6 LOG PLACEMENT 5
2.7 CHARCOAL LUMPS 6
2.8 CHARCOAL EMBERS 6
2.9 VERMICULITE 7
2.10 GLOWING EMBERS 7
3.1 FLAME CHARACTERISTICS 7
3.2 VENTURI ADJUSTMENT 7
NOTE: Changes, other than editorial, are denoted by a line in the margin.
1.0 GENERAL INFORMATION
This burner and log assembly are approved for use in the HD81 gas appliance only. They are not approved for
use as a stand alone appliance or in conjunction with any other appliance.
2.0 INSTALLATION
2.1 ACCESS PANEL
A. Once either door is removed (see
Installation Instructions), remove the
valve access panel and the 4 retaining
brackets located at the top of the fi rebox.
2.2 BURNER ASSEMBLY
A. Attach the burner assembly to the fi rebox
base with the screws supplied, making sure
the pilot assembly is closest to the valve
access opening.
Retaining
Brackets
Access
Panel
Valve
Access
Opening
Pilot
Assembly
W415-0713 / A / 11.09.10
Burner
Assembly
2.3 BULKHEADS
NOTE: Bulkhead covers need to be removed.
3
A. Connect the gas fl ex lines and the pilot line
to the gas bulkheads located under the valve
access opening. Be sure to match up the gas
manifold marked with a green dot with the
center bulkhead, also marked with a green
dot. Care must be taken to ensure the pilot
line isn’t damaged and ensuring gas tight
connections are made.
B. Connect the pilot electrode leads to the
bulkhead matching the 1/4” fl ag with the 1/4”
bulkhead spade and the 3/16” fl ag with the
3/16” spade.
C. Ensure the 2 venturi tubes are over the
orifi ces before lighting.
D. Check for gas leaks by brushing on a soap
and water solution. Do not use open fl ame.
E. After leak test has been performed re-install
access panel with gasket.
Bulkheads
See Thru
Window
Green
Dots
Gas
Pilot
Bulkhead
Pilot
Electrode
Pilot
Electrode
Leads
Venturi
Tube
Orifi ce
W415-0713 / A / 11.09.10
4
2.4 NIGHT LIGHT™ INSTALLATION
Your HD81 comes equipped with 2 “Night Lights™”. The lights
have been pre-wired and are controlled from the remote control.
Included with the burner assembly are the frames, lenses and
gaskets that need to be installed as shown.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the holes in the housing lamp may be observed.
The holes in the lamp housing are necessary for ventilation and must
not be covered.
2.5 HEARTH PANEL INSTALLATION
Hearth panels are shipped separate from unit and are included with the burner assembly and the logs. Due to
the brittle material of the panels, care must be taken not to bend or force them into place.
When shipped, the hearth panels range in varying shades of Sandstone. During initial use, the panels will darken
temporarily. The appearance of the panels will permanently lighten in color with use.
NIGHT LIGHT
COLOURED SIDE UP
GASKET
LENS
FRAME
INSTALL HEARTH PANELS IN THE FOLLOWING ORDER:
NOTE: Burner assembly must be installed fi rst.
A. Side brick panels or porcelain panels must be installed prior to
hearth panels. For brick panel installation see “GD844KT
DECORA TIVE BRICK PANEL - SANDST ONE” leafl et and PRP81
leafl et for porcelain panel installation.
B. Install the left and right hearth panels on both sides.
3
1
2
HEARTH PANELS
W415-0713 / A / 11.09.10
3
4
1
2
Loading...